Mist AP63 Premium Outdoor Hardware Guide d'installation

Catégorie
Antennes réseau
Taper
Guide d'installation
1
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
AP63 Hardware Installation Guide
Overview
The Mist AP63 is an IP67 rated outdoor access point which contains three
IEEE 802.11ax radios that deliver 4x4 MIMO with four spatial streams when
operating in multi-user (MU) or single-user (SU) mode.
2
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
I/O ports
ETH0/PoE IN 100/1000/2500BASE-T RJ45 interface that supports 802.3at/802.3bt
PoE PD
ETH1/PSE OUT 10/100/1000BASE-T RJ45 interface + 802.3af PSE (if PoE IN is 802.3bt)
3
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
4
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
AP63 Mounting Kit
Flush Mount Bracket
Articulating Mount Bracket
5
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
6
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
7
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
8
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
Technical Specifications:
Feature Description
Power options 802.3at/802.3bt PoE
Dimensions 285mm x 285mm x 85mm (11.2in x 11.2in x 3.3in)
Weight AP63: 3.4 kg (7.48 lbs)
AP63E: 3.9 kg (8.58 lbs)
Operating
temperature
AP63 / AP63E : -40° to 65° C without solar loading
AP63 / AP63E: -40° to 55° C with solar loading
Operating humidity 10% to 90% maximum relative humidity, non-condensing
Operating altitude 3,048m (10,000 ft)
Water and Dust IP67
Electromagnetic
emissions FCC Part 15 Class B
I/O 1 – 100/1000/2500BASE-T auto-sensing RJ-45 with PoE
1 – 10/100/1000BASE-T auto-sensing RJ-45 with PoE out
RF
2.4GHz or 5GHz - 4x4:4SS 802.11ax MU-MIMO & SU-MIMO
5GHz - 4x4:4SS 802.11ax MU-MIMO & SU-MIMO
2.4GHz / 5GHz scanning radio
2.4GHz BLE with Dynamic Antenna Array
Maximum PHY rate
Total maximum PHY rate – 4800 Mbps
5GHz – 2400 Mbps
2.4GHz or 5GHz – 1148 Mbps or 2400Mbps
Indicators Multi-color status LED
Wind Loading 60 meters/second
Compliance standards
UL 62368-1
CAN/CSA-C22.2 No. 62368-1-14
FCC Part 15.247, 15.407, 15.107, and 15.109
RSS-247
ICES-003 (Canada)
9
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
Warranty Information
The AP63 family of Access Points come with a 1 year limited warranty.
Ordering Information:
Access Points
AP63-US 802.11ax 4+4 Outdoor and BLE AP Internal Antenna
for the US Regulatory domain
AP63E-US 802.11ax 4+4 Outdoor and BLE AP External Antenna
for the US Regulatory domain
AP63-WW 802.11ax 4+4 Outdoor and BLE AP Internal Antenna
for the WW Regulatory domain
AP63E-WW 802.11ax 4+4 Outdoor and BLE AP External Antenna
for the WW Regulatory domain
Mounting brackets
APOUTBR
-
KIT
APOUTBR
-
FM and APOUT
BR
-
ART2
APOUTBR-FM Flush mount for Outdoor AP
APOUTBR-ART2
Articulating
mount for Outdoor AP
10
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
Regulatory Compliance Information:
If you need further assistance with purchasing the power source, please contact Juniper
Networks, Inc.
11
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
FCC Requirement for Operation in the United States of
America:
FCC Guideline for Human Exposure
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 31
cm between the radiator & your body.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
It must be Professionally installed.
12
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
Industry Canada
This device complies with RSS-247 of the Industry Canada Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause
undesired operation.
Ce dispositif est conforme à la norme CNR-247 d'Industrie Canada applicable aux appareils
radio exempts de licence. Son fonctionnement est sujet aux deux conditions suivantes: (1)
le dispositif ne doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit
accepter tout brouillage reçu, y compris un brouillage susceptible de provoquer un
fonctionnement indésirable.
Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 36
cm between the radiator & your body.
Déclaration d'exposition aux radiations:Cet équipement est conforme aux limites
d'exposition aux rayonnements IC établies pour un environnement non contrôlé. Cet
équipement doit être installé et utilisé avec un minimum de 36 cm de distance entre la
source de rayonnement et votre corps.
IC Caution
This radio transmitter (IC: 22068-AP63 / Model: AP63, AP63E) has been approved by
Innovation, Science, and Economic Development Canada to operate with the antenna
types listed below, with the maximum permissible gain indicated. Antenna types not
included in this list that have a gain greater than the maximum gain indicated for any type
listed are strictly prohibited for use with this device.
Avertissement
Le présent émetteur radio (IC: 22068-AP63 / Model: AP63, AP63E) a été approuvé par
Innovation, Sciences et Développement économique Canada pour fonctionner avec les
types d'antenne énumérés ci-dessous et ayant un gain admissible maximal d'antenne. Les
types d'antennes non inclus dans cette liste qui ont un gain supérieur au gain maximal
indiqué pour tout type listé sont strictement interdits pour une utilisation avec cet appareil.
13
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
Approved antenna(s) list:
AP63:
Ant Brand Model Name Antenna
Type
Antenna Gain (dBi) Radio
WLAN
2.4GHz
WLAN
5GHz
Bluetooth
1
~
4
Juniper
81XKAF15,G35
PIFA
-
6
-
5GHz
5
~
8
Juniper
81XKAF15,G35
PIFA
4
-
-
2.4
GHz
9
Juniper
81XKAF15,G35
PIFA
2.3
4.7
-
2
.4GH
z
/
5GHz
10
Juniper
81XKAF15,G35
PIFA
2.3
4.7
-
2
.4GH
z
/
5GHz
11
~
18
Juniper
81XKAF15,G35
PIFA
-
-
5.1
BT
1
9
Juniper
81XKAF15,G35
PIFA
-
-
4.3
BT
20
Juniper
81XKAF15,G35
PIFA
-
-
1.4
BT
AP63E:
Ant Port
Brand Model Name Antenna
Type
Antenna Gain (dBi) Radio
WLAN
2.4GHz
WLAN
5GHz
Bluetooth
1
1
~
6
Acceltex
ATS
-
OO
-
245
-
46-6NP-36
Omni
4
6
-
2.4GHz/5GH
z
2
1 ~
6
Acceltex
ATS
-
O
P
-
245
-
810-6NP-36
Patch
8
10
-
2.4GHz/5GH
z
3
~
10
Juniper
81XKAF15,G35
PIFA
-
-
5.1
BT
1
1
Juniper
81XKAF15,G35
PIFA
-
-
4.3
BT
12
Juniper
81XKAF15,G35
PIFA
-
-
1.4
BT
14
AP63 Hardware Installation Guide
Juniper Networks, Inc. (C) Copyright 2020. All Rights Reserved
CE
This device complies with the Radio Equipment Directive, 2014/53/EU, issued by the
Commission of the European Community.
Hereby, Juniper Networks, Inc. declares that the radio equipment type (AP63) is in
compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following:
https://www.mist.com/support/
The frequency and maximum EIRP Power in EU:
Bluetooth:
Frequency range (MHz) Maximum EIRP in EU (dBm)
2400
2483.5
8.19
WLAN:
Frequency range
(MHz)
Maximum EIRP in EU
(dBm) – Ext. Omni
Maximum EIRP in EU
(dBm) – Ext. Patch
Maximum EIRP in EU
(dBm) – Int. PIFA
2400
2483.5
19.99
1
9.99
19.99
5470
5725
29.99
29.99
29.93
5725
5850
13.94
13.98
13.97
The minimum distance between the user or bystander and the radiating structure of the
transmitter is 20 cm.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14

Mist AP63 Premium Outdoor Hardware Guide d'installation

Catégorie
Antennes réseau
Taper
Guide d'installation