LUNASEA LL64 Wireless Transmitter Mode d'emploi
- Taper
- Mode d'emploi
LunaSafe
Safety
Products
TM
www.lunasea.com1-800-272-0170
LL64
INSTRUCTIONS
Transmitter
Transmitter is a wearable device that has a approx 5 year
battery built in. When tranmitter comes in contact with
water it will send a signal to the receiver alarm which will
sound audible and visual alarm.
Transmitter Functions
Unlocked Position Locked Position
After threading the nylon strap through safety device and
back through the locking connector, turn locking button 90
degrees as shown using a coin or screwdriver.
Locking Wrist Strap
Receiver/Alarm
Wireless Charge Area
Internal Antenna
Pairing Indicator
Receive Indicator
Low Battery Indicator
Ready Indicator
Test Indicator
On/O Button Pair/Reset Button
Charge Indicator
Emergency Strobe Light
Audioable Alarm
Make sure the unit is fully charged by placing it standing up
on a charge pad. Then wait
until Charging Light goes o.
Charging Receiver
Momentarily press On/O Button to turn on. Unit initializes
and then Ready indicator blinks showing unit is in normal
operation.
Turn Receiver On
When battery becomes low the Low Bat Indicator will Blink.
Place unit on Charge Pad until battery is fully charged.
Charging light will then go o indicating full charge.
Low Battery
Press and hold the Check Button for 5 seconds then with wet
ngers, wet cloth or dipped in water across both gold pins.
You will see Pairing indicator blink multiple times showing
the the device has been paired. You can do this with up to 16
tranmitters.
To delete all pairing information, press and hold the Check
Button for 10 seconds. This will erase all pairing memory.
You may now pair new units to the receiver.
Pairing Receiver with Transmitter
Check Button Gold Pins
When Transmitter comes in contact with water the Strobe
Light on the Receiver activates and a Lound Alarm
activates. As soon as gold pins are dry the device stops
transmitting, however the Receiver Alarm will continue to
sound alarm. To reset the Receiver, press the Pair/Reset
Button or the On/O Button.
If On/O Button is pressed the unit will be in o state and
will no longer monitor.
Alarm in Progress
www.lunasea.com
LL63 Instructions Rev 3
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NOTE 1: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment o and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
IC WARNING
This device contains licence-exempt transmitter(s) that comply with Innovation, Science
and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the
following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme
aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes:
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
