Blaze King S.Z4991 & S.Z4992 – CL2714 MANTEL SHIELD Le manuel du propriétaire

Marque
Blaze King
Modèle
S.Z4991 & S.Z4992 – CL2714 MANTEL SHIELD
Taper
Le manuel du propriétaire
180-Z4991-Z4992 v1.00 July 10, 2020
Pour la version française de nos manuels S.V.P. vous référez à notre site web: www.blazeking.com
Manufactured By
Valley Comfort Systems Inc.
1290 Commercial Way
Penticton, BC V2A 3H5
CANADA
Phone: 250-493-7444
Fax: 250-493-5833
Blaze King Industries
146 A Street
Walla Walla, WA 99362
U.S.A.
Phone: (509) 522-2730
Fax: (509) 522-9803
S.Z4991 CL2714 MANTEL SHIELD 40”
S.Z4992 CL2714 MANTEL SHIELD 32”
CALIFORNIA PROPOSITION 65
WARNING: This product can expose you to chemicals including
benzene, which is known to the State of California to cause cancer and birth
defects or other reproductive harm. For more information:
www.P65Warnings.ca.gov
180-Z4991-Z4992 v1.00 July 10, 2020
Page 2
Z4991 MATEL SHIELD 40”
1. Leaving the unit in place, pull the rear most
shroud outward from the replace wall by 1/2”.
(Fig.1)
*Note: You may remove the front x2 shrouds if
more room to work is required.
2. WIth the Mantel Shield centered above the unit,
slide it down and behind the rear shroud until its
lower edge sits on top of the strongback on the
back face of the rear shroud. (Fig. 2)
3. Once satised with the position of the Mantel
Shield, push the rear shroud back against the
replace wall. (Fig.3)
*Note: If the front x2 shrouds were removed,
reinstall them at this point.
Fig.2
Fig.3
Fig.1
180-Z4991-Z4992 v1.00 July 10, 2020
Page 3
Z4992 MANTEL SHIELD 32”
1. Leaving the unit in place, pull the rear most
shroud outward from the replace wall by 1/2”.
(Fig.1)
*Note: You may remove the front x2 shrouds if
more room to work is required.
2. WIth the Mantel Shield centered above the unit,
slide it down and behind the rear shroud until its
lower edge sits on top of the strongback on the
back face of the rear shroud. (Fig. 2)
3. Once satised with the position of the Mantel
Shield, push the rear shroud back against the
replace wall. (Fig.3)
*Note: If the front x2 shrouds were removed,
reinstall them at this point.
Fig.2
Fig.3
Fig.1
  • Page 1 1
  • Page 2 2
  • Page 3 3

Blaze King S.Z4991 & S.Z4992 – CL2714 MANTEL SHIELD Le manuel du propriétaire

Marque
Blaze King
Modèle
S.Z4991 & S.Z4992 – CL2714 MANTEL SHIELD
Taper
Le manuel du propriétaire
Télécharger le PDF
rapport

dans d''autres langues

Documents connexes