Haltian TSLEAK Manuel utilisateur

Marque
Haltian
Modèle
TSLEAK
Taper
Manuel utilisateur

Ce manuel convient également à

LEAK USER INSTRUCTIONS
1. INTENDED USE OF LEAK
LEAK is a sensor device to detect water leakage. The device reports the resistance
value between the detecting pins and sends this information to a Wirepas protocol
mesh network. The device has also sensors for temperature, ambient light,
magnetism and acceleration and it includes an LED for indication purposes. It has
also sensors for humidity and air pressure but this data is not useful because of the
closed structure of the device. Typically LEAK is used together with MTXH Thingsee
Gateway in use cases where the measurements are performed in several locations
and this data is wirelessly collected and sent via 2G cellular connection to a data
server / cloud.
2. GENERAL
The device covers are ultra sonic welded together to get a robust structure against
moisture and dust. Batteries cannot be changed.
When delivered, the device is in a very low current consumption mode. When taken
into use, it needs to be switched on with a magnet switch tool:
Once the device is switched on, it wakes up and starts scanning for nearby Wirepas
devices having the same network ID.
3. PRECAUTIONS
Operating temperature range for the device is -20…+50 °C due to battery
specifications.
4. LEGAL NOTICES
Hereby, Haltian Products Oy declares that the radio equipment type LEAK is in
compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet
address: https://haltian.com
Haltian Products Oy vakuuttaa, etta radiolaitetyyppi LEAK on direktiivin 2014/53/EU
mukainen.
EU-vaatimustenmukaisuusvakuutuksen täysimittainen teksti on saatavilla
seuraavassa internetosoitteessa: https://haltian.com
LEAK operates at Bluetooth® 2.4 GHz frequency band. Maximum radio-frequency
power transmitted is +4.0 dBm.
Manufacturer name and address:
Haltian Products Oy
Yrttipellontie 1 D
90230 Oulu
Finland
FCC REQUIREMENTS FOR OPERATION IN THE UNITED STATES
FCC Information for the User
This product does not contain any user serviceable components and is to be used
with approved, internal antennas only. Any product changes of modifications will
invalidate all applicable regulatory certifications and approvals.
FCC Guidelines for human Exposure
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance of 10 mm between the radiator and your body. This transmitter
must not be co-located or operating in conjunction with any other antenna or
transmitter.
Federal Communications Commission Statement
This device complies with Part 15 Rules. Operation is subject to the following two
conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received, including interference that may
cause undesired operation.
FCC Radio Frequency Interference Warnings & Instructions
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following methods:
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an electrical outlet on a circuit different from that
which the radio receiver is connected
• Consult the dealer or and experienced radio/TV technician for help
FCC Caution
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1) This device may not cause harmful interference, and
2) this device must accept any interference received, including interference
that may cause undesired operation.
Industry Canada:
This device complies with RSS-247 of the Industry Canada Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Ce dispositif est conforme à la nor me RSS-247 d'Industrie Canada applicable aux
appareils radio exempts de licence. Son fonctionnement est sujet aux deux
conditions suivantes: (1) le dispositif ne doit pas produire de brouillage
préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y compris un
brouillage susceptible de provoquer un fonctionnement indésirable
Radiation Exposure Statement :
This device complies with ISED radiation exposure limits set forth for an
uncontrolled environment.
NOTE IMPORTANTE: Déclaration d'exposition aux radiations:
Cet équipement est conforme aux limites d'exposition aux rayonnements ISED
établies pour un environnement non contrôlé. Cet équipement doit être installé et
utilisé avec une distance minimale de 10 mm entre le radiateur et votre corps.
FCC ID: 2AEU3TSLEAK
IC ID: 20236-TSLEAK
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

Haltian TSLEAK Manuel utilisateur

Marque
Haltian
Modèle
TSLEAK
Taper
Manuel utilisateur
Ce manuel convient également à
Télécharger le PDF
rapport

dans d''autres langues

Documents connexes

Autres documents