4F8135

Li-Ion Rapid Battery Charger

Model K8500

User’s Guide

Thank you for purchasing the KODAK Li-Ion Rapid Battery

Charger. The battery needs to be charged before using

and takes approximately 3 hours or less. The battery can

be charged and discharged approximately 300 times.

Additional KODAK Li-Ion Batteries are available from

contacts facing the +/– contact points in the charger.

3. Insert the plug that matches your power type then

plug the charger into a power outlet.

4. Verify that the red charge indicator light on the charger

turns on. If the light does not turn on, verify that the

battery is inserted correctly.

5. Remove the battery and unplug the charger when the

red indicator light turns green. Charging takes

approximately 3 hours or less.

IMPORTANT SAFETY

attachment plug adapter of the proper configuration

for the power outlet. This battery charger is intended

to be correctly oriented in a vertical or floor mount

position.

CAUTION:

• Charge only compatible Li-Ion rechargeable batteries.

Other types of batteries may burst causing personal

injury and damage.

• Risk of electric shock. Use only in dry locations.

• Do not operate charger if it has been damaged.

metal wires) into the charger.

• Do not modify or disassemble.

• If something appears wrong with the charger and/or

batteries, disconnect from the electric outlet

immediately.

• Keep out of reach of infants. Children may use only

under strict parental supervision.

• Store in a dry, cool place.

Recommended temperature ranges for use:

Li-Ion

In Europe: For human/environmental

protection, it is your responsibility to

dispose of this equipment at a collection

facility established for this purpose

(separate from municipal waste). For more information,

contact your retailer, collection facility, or appropriate

local authorities; or visit www.kodak.com/go/recycle.

(Product weight: 85 g.)

1

3

instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will

not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1) reorient or relocate the receiving antenna; 2) increase the separation between the equipment and the receiver; 3) connect

the equipment to an outlet on a circuit different from that to which the receiver is connected; 4) consult the dealer or an

experienced radio/TV technician for additional suggestions.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority

to operate the equipment. Where shielded interface cables have been provided with the product or specified additional components

or accessories elsewhere defined to be used with the installation of the product, they must be used in order to ensure compliance

Eastman Kodak Company

Rochester, NY 14650 U.S.A.

© Eastman Kodak Company, 2008.

MC/MR/TM: Kodak. 4J8135

www.kodak.com/go/accessories