Equator 2440 Manuel utilisateur

Catégorie
Lave-vaisselle
Taper
Manuel utilisateur
There is one button, located at the center of the control panel, to
turn the dishwasher on or off and also to start the wash program.
Press the On/Off button for 3 seconds to power the appliance on.
Select the Wash Programs by pressing the Program button. Once
selected, the Program number (e.g. P1, P2) flashes on the Display
Panel and also the number of minutes for the cycle.
If Program button is held down for 3 seconds, the program is
cancelled.
Half Load button - Press this button to select either upper or lower
basket, if dishwasher is only half full. The red LED light will show
your selection.
Delay button - You can delay the start of the program.
Pressing this button will ad time in one-hour increments.
to cancel Delay, press and hold the Start button for 3 seconds.
Options button - You may select:
Sanitize - increases the water temperature in the final rinse.
High Temp - increases water temperature and wash time.
Extra Dry - increases water temperature.
Rinse Aid - If rinse aid needs to be added, the Rinse Aid indicator
light will illuminate.
Start / Pause button
2440 (WBT / BBT / SBT)
15 Place setting
120V / 60Hz / 12A
1100 W
1400 W
4.35 - 145psi
3.4 Gallons
93.26 / 96.7
33.9 x 23.5 x 22.4 (inch)
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28
  • Page 29 29
  • Page 30 30
  • Page 31 31
  • Page 32 32

Equator 2440 Manuel utilisateur

Catégorie
Lave-vaisselle
Taper
Manuel utilisateur

dans d''autres langues