ALLPOWERS R600 Portable Power Station Mode d'emploi
- Taper
- Mode d'emploi
R600
R600
R600
R600
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
RadiationExposureStatement
ThisdevicecomplieswithFCCRFradiationexposurelimitssetforthforanuncontrolled
environment.Thistransmittermustnotbeco‐locatedoroperatinginconjunctionwithanyother
antennaortransmitter.Duringtheoperationofdeviceadistanceof15cmsurroundingthe
deviceand20cmabovethetopsurfaceofthedevicemustberespected.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm
etween the radiator & your body.
For wireless charger
For Bluetooth
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licenceexempt RSS(s).
Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that
may cause undesired operation of the device.
Cet appareil contient des émetteurs/récepteurs exempts de licence qui sont conformes aux
RSS sans licence d'Innovation, Sciences et Développement économique Canada.
L'exploitation est soumise aux deux conditions suivantes :
1. Cet appareil ne doit pas provoquer d'interférences.
2. Cet appareil doit accepter toute interférence, y compris les interférences qui
peut entraîner un fonctionnement indésirable de l'appareil.
This equipment complies with Canada radiation exposure limits set forth
for an uncontrolled environment.
During the operation of device a distance of 10 cm surrounding the
device and 10 cm above the top surface of the device must be
respected.
Cet équipement est conforme Canada limites d'exposition aux radiations
dans un environnement non contrôlé.
au cours de l'opération de l'appareil sur une distance de 10 cm autour de
l'appareil et de 10 cm au - dessus de la surface supérieure de l'appareil
doit être respecté.
For Bluetooth
For wireless charger
This equipment complies with Canada radiation exposure limits set forth for uncontrolled
environments. This equipment should be installed and operated with a minimum distance of
20cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
Cet équipement est conforme aux limites d’exposition aux radiations définies par le Canada
pour des environnements non contrôlés. Cet équipement doit être installé et utilisé à une
distance minimum de 20 cm entre l’antenne et votre corps.
Cet émetteur ne doit pas être installé au même endroit ni utilisé avec une autre antenne ou
un autre émetteur.
-
1
-
2
-
3
