Lumination Decaux Max Series Goofring LED Luminaire Guide d'installation

Taper
Guide d'installation
LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved. Information and specifications subject to change
without notice. All values are design or typical values when measured under laboratory conditions.
Page 1 of 4
(Rev 05/23/23)
IND285-Lumination-Decaux-Max-Goofring-Installation-Guide_R01
Installation Guide
IND285
Lumination® Decaux Max
LED Downlight Goofring
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Save These Instructions
Use only in the manner intended by the manufacturer. If you have any questions, contact the manufacturer.
Compatibility
Compatible with RC10 type xtures.
Hole diameter size must be between 11.7–12.3 in.
Components
Item Description Qty.
1 Adapter 1
2 L-bracket 3
3 Bolt 3
4 Wingnut 3
5 Star washer 3
1
2 3 4 5
LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved. Information and specifications subject to change
without notice. All values are design or typical values when measured under laboratory conditions.
Page 2 of 4
(Rev 05/23/23)
IND285-Lumination-Decaux-Max-Goofring-Installation-Guide_R01
Lumination® Decaux Max Installation Guide
Unit Installation
Loosen remaining L-bracket and insert the adapter in the hole.
NOTE: Make sure the L-bracket is on top of the ceiling.
2
Ceiling
3
Above ceiling
Lower the L-bracket and tighten the
wingnut rmly.
Install the remaining L-brackets and ensure all wingnuts are tightened.
4
Wingnut
Bolt
Star washer
65
Make sure there is no gap between the adaptor and that
the adapter is well centered. See RC10 manual for luminaire installation instructions.
Remove 2 L-brackets.
1
Page 3 of 4
(Rev 05/23/23)
IND285-Lumination-Decaux-Max-Goofring-Installation-Guide_R01
Page 3 of 4
(Rev 05/23/23)
IND285-Lumination-Decaux-Max-Goofring-Installation-Guide_R01
Page 3 of 4
(Rev 05/23/23)
IND285-Lumination-Decaux-Max-Goofring-Installation-Guide_R01
LED.com
© 2023 Current Lighting Solutions, LLC. Tous droits réservés. Les informations fournies sont sujetes à modifications sans
préavis. Toutes les valeurs données sont théoriques ou typiques lorsque mesurées sous conditions de laboratoire.
Guide d’Installation
IND285
Lumination® Decaux Max
LED Downlight Goofring
AVANT DE COMMENCER
Lisez ces instructions entièrement et attentivement
Conservez ces instructions
N’utilisez que de la manière prévue par fabricant. Si vous avez des questions, contactez le fabricant.
Compatibilité
Compatible avec les appareils du type RC10.
Le diamètre du trou doit être entre 11,7 et 12,3 po (297 et 312 mm).
Composants
Poste Description Qté.
1 Adaptateur 1
2 Support en “L” 3
3 Vis 3
4 Écrou papillon 3
5 Rondelle étoile 3
1
2 3 4 5
Page 4 of 4
(Rev 05/23/23)
IND285-Lumination-Decaux-Max-Goofring-Installation-Guide_R01
Page 4 of 4
(Rev 05/23/23)
IND285-Lumination-Decaux-Max-Goofring-Installation-Guide_R01
Page 4 of 4
(Rev 05/23/23)
IND285-Lumination-Decaux-Max-Goofring-Installation-Guide_R01
LED.com
© 2023 Current Lighting Solutions, LLC. Tous droits réservés. Les informations fournies sont sujetes à modifications sans
préavis. Toutes les valeurs données sont théoriques ou typiques lorsque mesurées sous conditions de laboratoire.
Lumination® Decaux Max Guide d’Installation
Installation de l’adaptateur
Desserrez le support en “L” restant et insérez l’adaptateur dans le trou.
REMARQUE: Assurez-vous que le support en “L” se trouve au-dessus du plafond.
2
3
Au-dessus du
plafond
Abaissez les supports en “L” et serrez
fermement les écrous papillons. Installez les supports en “L” restants et assurez-vous que les écrous papillons soient
bien serrés.
4
65
Assurez-vous qu’il n’y a pas de jeu entre l’adaptateur et
que celui-ci est bien centré. Voir le manuel RC10 pour les instructions d’installation du
luminaire.
Enlever les deux supports en “L”
1
Wingnut
Bolt
Star washer
Ceiling
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Lumination Decaux Max Series Goofring LED Luminaire Guide d'installation

Taper
Guide d'installation