2
Thank you for purchasing Inverto’s advanced Unicable II multiswitch and we are certain it
will meet your expectations. Before installing and operating the product, please read the
following instructions and recommendations. We suggest that you keep this manual for
future use.
Warranty
This Unicable II multiswitch is designed for the distribution of satellite and terrestrial televi-
sion and radio signals in home installations. The warranty does not apply for products used
for other purposes than those specified herein. The user/installer shall be responsible for any
damage incurred as a result of not using the product according to the instructions in this
manual.
Installation location
The product shall be installed on a wall or other hard inflammable surface.
The product shall be in no case held only with the connected cables.
Place the product in a dry environment where it is not exposed to rain or running water.
Do not install the product close to heat sources or in places exposed to direct sunlight.
Product installation
To distribute the best signal quality across your installation
we recommend connecting the product inputs and outputs
using high-quality coaxial cables and F-connectors designed
for satellite TV distribution. Use a highly shielded coaxial
cables with minimum shielding of 90dB. If you use wall
sockets to loop-through the STB outputs, make sure the wall
sockets were designed for satellite TV distribution allowing
bidirectional signal propagation.
The satellite input ports can be connected directly to a Quattro/
Wideband LNB (pay attention to the port designations and
the correct position of the LNB type switch SW1) or cascade
to another Multiswitch unit.
The DC-input port of the Multiswitch unit powers the
satellite trunk lines to power the connected LNB. It also
powers the unit’s built-in Terrestrial amplifier as well as the
Terrestrial amplifier of cascaded units. The Trunk power LED
will turn green when the Trunk lines are powered.
The output ports are powered by the connected STBs to enable super low power
consumption of the unit and allow to power the maximum number of cascaded switches
through a single power supply unit.
If a connected STB is not able to power the port, a power inserter can be utilized*.
* Power Inserter and AC/DC power adapters are not included and can be purchased separately.
Notes:
For optimal performances, satellite loop-through outputs that are not used shall be terminated
with 75ohm DC-block terminating resistors. The Terrestrial loop-through output port shall be
terminated with a 75ohm terminating resistor. It is also recommended to terminate unused
STB output ports with 75ohm terminating resistors.
IMPORTANT: Ground the multiswitch device using its earthing terminals.
37
116
184
146
210
Unicable II
®
Cascadable switch with Terrestrial input
and 8 Sky dSCR/SatCR/Legacy + equalized
Terrestrial outputs
ISKY-UST111-CUO8O-16P
Item: 6099
FTA Communication Technologies S.à r.l., 17 Route de Luxembourg, Gonderange L-6182, Luxembourg
WB
Vertical WB
Horizontal WB
Vertical WB
Horizontal