Chief PAC717 Guide d'installation

Chief
Marque
Chief
Modèle
PAC717
Catégorie
Kits de montage
Taper
Guide d'installation
INSTALLATION INSTRUCTIONS
Instrucciones de instalación
Installationsanleitung
Instruções de Instalação
Istruzioni di installazione
Installatie-instructies
Instructions d´installation
Literature Shelf
Spanish Product Description
German Product Description
Portuguese Product Description
Italian Product Description
Dutch Product Description
French Product Description
PAC717
PAC717 Installation Instructions
2
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
IMPORTANT WARNINGS AND
CAUTIONS!
WARNING:
A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION:
A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING:
Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING:
Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all literature and accessories mounted on the PAC717 does
not exceed 25 lbs (11.34 kg).
DIMENSIONS
7.06 DISTANCE
FROM CART/STAND
179.3
70°
12.39 INSIDE
314.7
2.90
73.7
12.50
Installation Instructions PAC717
3
LEGEND
Tighten Fastener
Apretar elemento de fijación
Befestigungsteil festziehen
Apertar fixador
Serrare il fissaggio
Bevestiging vastdraaien
Serrez les fixations
Loosen Fastener
Aflojar elemento de fijación
Befestigungsteil lösen
Desapertar fixador
Allentare il fissaggio
Bevestiging losdraaien
Desserrez les fixations
Phillips Screwdriver
Destornillador Phillips
Kreuzschlitzschraubendreher
Chave de fendas Phillips
Cacciavite a stella
Kruiskopschroevendraaier
Tournevis à pointe cruciforme
Open-Ended Wrench
Llave de boca
Gabelschlüssel
Chave de bocas
Chiave a punte aperte
Steeksleutel
Clé à fourche
By Hand
A mano
Von Hand
Com a mão
A mano
Met de hand
À la main
Hex-Head Wrench
Llave de cabeza hexagonal
Sechskantschlüssel
Chave de cabeça sextavada
Chiave esagonale
Zeskantsleutel
Clé à tête hexagonale
Pencil Mark
Marcar con lápiz
Stiftmarkierung
Marcar com lápis
Segno a matita
Potloodmerkteken
Marquage au crayon
Drill Hole
Perforar
Bohrloch
Fazer furo
Praticare un foro
Gat boren
Percez un trou
Adjust
Ajustar
Einstellen
Ajustar
Regolare
Afstellen
Ajuster
Remove
Quitar
Entfernen
Remover
Rimuovere
Verwijderen
Retirez
Optional
Opcional
Optional
Opcional
Opzionale
Optie
En option
Security Wrench
Llave de seguridad
Sicherheitsschlüssel
Chave de segurança
Chiave di sicurezza
Veiligheidssleutel
Clé de sécurité
PAC717 Installation Instructions
4
TOOLS REQUIRED FOR INSTALLATION
PARTS
1/2" (12.7mm)
A(1)
B(1)
C(2)
D(1)
E(4)
3/8"
[Literature tray]
[Shelf column mount]
[5/16-18 knob]
[Shelf bracket]
Installation Instructions PAC717
5
Assembly And Installation
Assemble Literature Tray
1. Place shelf column mount (B) over bolts on back of literature
tray (A). (See Figure 1)
2. Install four 3/8" hex nuts (E) to bolts on back of literature tray
(A) to secure shelf column mount (B) to tray. (See Figure 1)
Figure 1
3. Place shelf bracket (D) over bolts on flanges of shelf column
mount (B). (See Figure 2)
4. Thread two 5/16-18" knobs (C) onto bolts until shelf bracket
is secured to shelf column mount. (See Figure 2)
Figure 2
Attach Literature Tray to Cart/Stand
1. Loosen back bracket (D) by turning both knobs
counterclockwise. Do NOT remove knobs. (See Figure 3)
Figure 3
2. Slide bracket to the left until it disengages from the right
stud. (See Figure 4)
Figure 4
3. Let the bracket drop down and hang from the shelf’s left
stud. (See Figure 5)
2
(E) x 4
(A)
(B)
1
(B)
(D)
(C) x 2
3
(C) x 2
1
Knobs shown
removed for
viewing purposes
only
(D)
Knobs shown
removed for
viewing purposes
only
(D)
2
PAC717 Installation Instructions
6
Figure 5
4. Position shelf column mount (B) around lower extrusion of
cart/stand at desired mounting height. (See Figure 6)
5. Raise shelf bracket and hook over shelf’s right stud. (See
Figure 6)
6. Turn both knobs clockwise to tighten the shelf in place. (See
Figure 6)
Figure 6
Adjustments
Height Adjustment
1. Loosen back bracket (D) by turning both knobs
counterclockwise. Do NOT remove knobs. (See Figure 7)
2. Slide bracket to the left until it disengages from the right
stud. (See Figure 7)
Figure 7
3. Let the bracket drop down and hang from the shelf’s left
stud. (See Figure 8)
4. Adjust literature tray to desired height. (See Figure 8)
Figure 8
5. Raise shelf bracket and hook over shelf’s right stud. (See
Figure 9)
6. Turn both knobs clockwise to tighten the shelf in place. (See
Figure 9)
Knobs shown
removed for
viewing purposes
only
5
6
(C) x 2
2
(C) x 2
1
3
4
Installation Instructions PAC717
7
Figure 9
5
6
(C) x 2
PAC717 Installation Instructions
USA/International A 8401 Eagle Creek Parkway, Savage, MN 55378
P 800.582.6480 / 952.894.6280
F 877.894.6918 / 952.894.6918
Europe A Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands
P +31 (0)40 2668620
F +31 (0)40 2668615
Asia Pacific A Room 24F, Block D, Lily YinDu International Building
LuoGang, BuJi Town, Shenzhen, CHINA.
P +86-755-8996 9226
F +86-755-8996 9217
Chief Manufacturing, a products division
of Milestone AV Technologies
8807-002002 REV 01
©2009 Milestone AV Technologies, a
Duchossois Group Company
www.chiefmfg.com
05/09
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Chief PAC717 Guide d'installation

Chief
Marque
Chief
Modèle
PAC717
Catégorie
Kits de montage
Taper
Guide d'installation
Télécharger le PDF
rapport

dans d''autres langues

Documents connexes

Autres documents