Chief FCAC Guide d'installation

Catégorie
Kits de montage
Taper
Guide d'installation
INSTALLATION INSTRUCTIONS
Ceiling Mount Extrusion Connector
Spanish Product Description
German Product Description
Portuguese Product Description
Italian Product Description
Dutch Product Description
French Product Description
FCAC
FCAC Installation Instructions
2
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING: Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! Adding the
FCAC connector accessory does NOT change the weight
capacity listed for the mount. Consult (Table 1) for mounting
system’s weight capacity details.
WARNING: Use this accessory only for its intended use as
described in these instructions. Do not use attachments not
recommended by the manufacturer.
WARNING: Never operate this accessory if it is damaged.
Return the accessory to a service center for examination and
repair.
WARNING: Do not use this product outdoors.
Table 1: Weight Capacities
WARNING: Displays may NOT be attached to the FCAC
OR mounted across the FCAC. The FCAC is NOT intended
to be a load-bearing accessory.
NOTE: The FCAC is intended to assist with alignment of LCM
menu boards and ceiling mounted video walls.
NOTE: The FCAC is intended to be used with:
LCM Ceiling Mounted Menu Boards Series
LCM Ceiling Mounted Video Walls Series
--SAVE THESE INSTRUCTIONS--
MODEL Max Weight
Allowed for EACH
Display
Max Weight
Capacity of
Mounting System
LCM2X2U
125 lbs
(56.7 kg)
500 lbs
(226.8 kg)
LCM3X2U
125 lbs
(56.7 kg)
750 lbs
(340.2 kg)
LCM3X3U
85 lbs
(38.6 kg)
765 lbs
(347.0 kg)
LCM2X1U
125 lbs
(56.7 kg)
250 lbs
(113.4 kg)
LCM2X1UP
125 lbs
(56.7 kg)
250 lbs
(113.4 kg)
LCM3X1U
125 lbs
(56.7 kg)
375 lbs
(170.1 kg)
LCM3X1UP
125 lbs
(56.7 kg)
375 lbs
(170.1 kg)
Installation Instructions FCAC
3
DIMENSIONS
LEGEND
0.28
7.1
A
SHOWN WITH LCM2X1U
DETAIL A
SCALE 1 : 6
B
SHOWN WITH LCM2X1U
DETAIL B
SCALE 1 : 8
DIMENSIONS: INCHES
[MILLIMETERS]
Tighten Fastener
Apretar elemento de fijación
Befestigungsteil festziehen
Apertar fixador
Serrare il fissaggio
Bevestiging vastdraaien
Serrez les fixations
Loosen Fastener
Aflojar elemento de fijación
Befestigungsteil lösen
Desapertar fixador
Allentare il fissaggio
Bevestiging losdraaien
Desserrez les fixations
Phillips Screwdriver
Destornillador Phillips
Kreuzschlitzschraubendreher
Chave de fendas Phillips
Cacciavite a stella
Kruiskopschroevendraaier
Tournevis à pointe cruciforme
Hex-Head Wrench
Llave de cabeza hexagonal
Sechskantschlüssel
Chave de cabeça sextavada
Chiave esagonale
Zeskantsleutel
Clé à tête hexagonale
FCAC Installation Instructions
4
TOOLS REQUIRED FOR INSTALLATION
PARTS
7/16"
B (4)
[T-slot nut]
A (1)
[FCAC]
C (8)
1/4-20
Installation Instructions FCAC
5
INSTALLATION
NOTE: The FCAC is intended to assist with alignment of LCM
menu boards and ceiling mounted video walls.
WARNING: Displays may NOT be attached to the FCAC
OR mounted across the FCAC. The FCAC isNOT intended
to be a load-bearing accessory.
1. Assemble LCM Ceiling Mounted Menu Boards Series or
LCM Ceiling Mounted Video Walls Series, according to
included installation instructions.
2. Rotate end cap on one end of rail by loosening one screw
and removing one screw holding end cap to rail. (See
Figure 1)
3. Repeat Step 2 for end of adjacent rail. (See Figure 1)
Figure 1
4. Insert two T-slot nuts (B) into rail. (See Figure 2)
5. Rotate end cap back into position and fasten with screws
loosened or removed in Steps 2 and 3. (See Figure 2)
6. Repeat Steps 4 and 5 for end of adjacent rail. (See Figure 2)
Figure 2
2
3
5
(B) x 2
4
(B) x 2
6
6
FCAC Installation Instructions
6
7. Attach FCAC (A) to T-slot nuts (B) using eight 1/4-20 hex
nuts (C). (See Figure 3)
NOTE: See the maximum spacing and minimum spacing
examples of the FCAC. (See Figure 3)
Figure 3
7
(C) x 8
(A)
(B)
Minimum
spacing
Maximum
spacing
Installation Instructions FCAC
7
FCAC Installation Instructions
USA/International A 6436 City West Parkway, Eden Prairie, MN 55344
P 800.582.6480 / 952.225.6000
F 877.894.6918 / 952.894.6918
Europe A Franklinstraat 14, 6003 DK Weert, Netherlands
P +31 (0) 495 580 852
F +31 (0) 495 580 845
Asia Pacific A Office No. 1 on 12/F, Shatin Galleria
18-24 Shan Mei Street
Fotan, Shatin, Hong Kong
P 852 2145 4099
F 852 2145 4477
Chief Manufacturing, a products division
of Milestone AV Technologies
8800-002514 Rev00
2013 Milestone AV Technologies, a
Duchossois Group Company
www.chiefmfg.com
12/13
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Chief FCAC Guide d'installation

Catégorie
Kits de montage
Taper
Guide d'installation

dans d''autres langues