INSTALLATION INSTRUCTIONS
Instrucciones de instalación
Installationsanleitung
Instruções de Instalação
Istruzioni di installazione
Installatie-instructies
Instructions d´installation
Center Speaker Bracket
Spanish Product Description
German Product Description
Portuguese Product Description
Italian Product Description
Dutch Product Description
French Product Description
TA350
TA350 Installation Instructions
2
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
IMPORTANT WARNINGS AND
CAUTIONS!
WARNING: A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING: Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING: Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all equipment and accessories mounted on the TA350
bracket does not exceed 10 lbs (4.54 kg).
DIMENSIONS
475.6
18.73
DISTANCE TO C/L OF
TS3XX SERIES MOUNTS
483.6
19.04
DISTANCE TO C/L OF
TS5XX SERIES MOUNTS
375.6
14.79
DISTANCE TO C/L OF
TS5XX SERIES MOUNT
367.7
14.48
DISTANCE TO C/L OF
TS3XX SERIES MOUNTS
WITH LONG EXTENSION BRACKET
1.63
41.3
.28
7.1
406.4
16.00
20.6
.81
114.3
4.50
ADJUSTMENT
.298
WITH SHORT EXTENSION BRACKET
Installation Instructions TA350
3
LEGEND
Tighten Fastener
Apretar elemento de fijación
Befestigungsteil festziehen
Apertar fixador
Serrare il fissaggio
Bevestiging vastdraaien
Serrez les fixations
Loosen Fastener
Aflojar elemento de fijación
Befestigungsteil lösen
Desapertar fixador
Allentare il fissaggio
Bevestiging losdraaien
Desserrez les fixations
Phillips Screwdriver
Destornillador Phillips
Kreuzschlitzschraubendreher
Chave de fendas Phillips
Cacciavite a stella
Kruiskopschroevendraaier
Tournevis à pointe cruciforme
Open-Ended Wrench
Llave de boca
Gabelschlüssel
Chave de bocas
Chiave a punte aperte
Steeksleutel
Clé à fourche
By Hand
A mano
Von Hand
Com a mão
A mano
Met de hand
À la main
Hex-Head Wrench
Llave de cabeza hexagonal
Sechskantschlüssel
Chave de cabeça sextavada
Chiave esagonale
Zeskantsleutel
Clé à tête hexagonale
Pencil Mark
Marcar con lápiz
Stiftmarkierung
Marcar com lápis
Segno a matita
Potloodmerkteken
Marquage au crayon
Drill Hole
Perforar
Bohrloch
Fazer furo
Praticare un foro
Gat boren
Percez un trou
Adjust
Ajustar
Einstellen
Ajustar
Regolare
Afstellen
Ajuster
Remove
Quitar
Entfernen
Remover
Rimuovere
Verwijderen
Retirez
Optional
Opcional
Optional
Opcional
Opzionale
Optie
En option
Security Wrench
Llave de seguridad
Sicherheitsschlüssel
Chave de segurança
Chiave di sicurezza
Veiligheidssleutel
Clé de sécurité
TA350 Installation Instructions
4
TOOLS REQUIRED FOR INSTALLATION
PARTS
5/32" (included)
1/8" (included)
#2
3/8"
A (1) B (1)
C (1)
[attachment bracket]
D (1)
[short extension bracket]
E (6)
1/4-20 x 3/8"
J (4) 5/32"
K (3) 1/8"
L (1) M (1)
#10-24 x 1/2" 1/4"
[center speaker bracket]
[long extension bracket]
F (4)
#10-24 x 3/8" G (1)
1/4-20 x 3/8" H (4)
#10-24"
Installation Instructions TA350
5
Installation
Bracket Assembly
With Short Extension Bracket
1. Use two 1/4-20 x 3/8" button head cap screws (E) and one
1/4-20 x 3/8" flat head cap screw (G) to attach short
extension bracket (D) to center speaker bracket (B). (See
Figure 1)
Figure 1
2. Use three 1/4-20 x 3/8" button head cap screws (E) and
three 1/4" washers (K) to secure attachment bracket (A) to
short extension bracket (D). (See Figure 2)
Figure 2
With Long Extension Bracket
1. Use three 1/4-20 x 3/8" button head cap screws (E) to
attach long extension bracket (C) to center speaker bracket
(B). (See Figure 3)
Figure 3
2. Use three 1/4-20 x 3/8" button head cap screws (E) and
three 1/4" washers (K) to secure attachment bracket (A) to
long extension bracket (C). (See Figure 4)
Figure 4
(E) x 2
(G)
1
1
(D)
(B)
(E) x 3
2
(D)
(A)
(K) x 3
1
(E) x 3
(C)
(B)
(A)
(C)
(E) x 3
(K) x 3
2
TA350 Installation Instructions
6
Install Attachment Bracket to Faceplate
NOTE: TA350 center channel speaker brackets may be
installed above or below the display.
TS525 or iCF50 Installation
NOTE: Display does NOT have to be removed to attach
bracket to TS525 or iCF50 faceplate.
1. Use four #10-24 x 3/8" button head cap screws (F) to
connect attachment bracket (A) to upper or lower holes on
swing arm faceplate. (See Figure 5) and (See Figure 6)
Figure 5
Figure 6
TS3XX or iCF30 Installation
1. If already installed, remove display from faceplate. See
swing arm installation instructions for details.
2. Use four #10-24 x 1/2" Phillips flat head cap screws (J) and
four #10-24 lock nuts (H) to connect attachment bracket (A)
to faceplate. (See Figure 7) and (See Figure 8)
Figure 7
Figure 8
3. Reinstall display to faceplate. See swing arm installation
instructions for details.
(display not shown for clarity)
(F) x 4
1
(top installation)
(display not shown for clarity)
(F) x 4
1
(bottom installation)
(top installation)
(H) x 4
2
(J) x 4
(bottom installation)
2
(J) x 4
(H) x 4
(A)
Installation Instructions TA350
7
Attach to Side Speaker Bracket (if applicable)
If side speaker brackets (TA300) have been installed to mount
side speakers, the attachment bracket should be attached to
the horizontal rail of the side speaker brackets for additional
support.
IMPORTANT ! : If installing below display,install both
side speaker brackets prior to installing center speaker
bracket to ensure an even mount.
1. Use two #10-24 x 1/2" button head cap screws and two #10
washers (provided with TA300) to connect horizontal
bracket on side speaker brackets to attachment bracket (A).
(See Figure 9)
Figure 9
Center Speaker Installation
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all equipment and accessories mounted on the TA350
bracket does not exceed 10 lbs (4.54 kg).
1. Attach center speaker to center speaker bracket (B) using
appropriate hardware (not provided). (See Figure 10)
Figure 10
Adjustments
Height Adjustment
1. Loosen three 1/4-20 x 3/8" button head cap screws (E)
holding extension bracket (C or D) to attachment bracket
(A). (See Figure 11)
2. Adjust height of center speaker bracket (B) as desired. (See
Figure 11)
3. Tighten three three 1/4-20 x 3/8" button head cap screws
(E) holding extension bracket (C or D) to attachment
bracket (A). (See Figure 11) or (See Figure 12)
Figure 11
Figure 12
x 2
x 2
(A)
TA300
1
speaker (example)
2
13
(long extension)
(short extension)
13
TA350 Installation Instructions
USA/International A 8401 Eagle Creek Parkway, Savage, MN 55378
P800.582.6480 / 952.894.6280
F877.894.6918 / 952.894.6918
Europe A Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands
P+31 (0)40 2668620
F+31 (0)40 2668615
Asia Pacific A Office No. 1 on 12/F, Shatin Galleria
18-24 Shan Mei Street
Fotan, Shatin, Hong Kong
P852 2145 4099
F852 2145 4477
Chief Manufacturing, a products division
of Milestone AV Technologies
8805-002019 Rev01
2011 Milestone AV Technologies, a
Duchossois Group Company
www.chiefmfg.com
08/11
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
dans d''autres langues
- English: Chief TA350 Installation guide
Documents connexes
-
Chief TA300 Guide d'installation
-
Chief TA200 Guide d'installation
-
-
Chief Manufacturing TA410 Manuel utilisateur
-
-
-
-
-
-