ActionTec API7220 Manuel utilisateur

ActionTec
Marque
ActionTec
Modèle
API7220
Catégorie
Antennes réseau
Taper
Manuel utilisateur
API7220
Technical Specifications
V 0.5
1. Overview
This document specifies the hardware features and requirements for ACTIONTEC API7220 11ax 2x2
indoor AP.
Model Enclosure Features
API7220
AM2
o
Chipset:
IPQ
60
00
;
o 5G radio: QCN5052 a/n/ac/ax, 2x2 , 1.2Gbps;
o 2.4G radio: QCN5022 b/g/n/ac/ax , 2x2, 574Mbps;
o 1x BLE5.0: nRF52810;
o 2x Integrated dual-band antennas;
o 1x BLE antenna;
o 16MB SPI NOR Flash;
o 128MB BGA NAND Flash;
o 512MB 16bit DDR3L RAM;
** According to QCA, 256MB DDR has the
limitation: 4 VAPs/ Radio, 64 STA/ Radio
o 1x RJ45 GbE WAN, with 802.3at PoE(PD);
o 1x RJ45 GbE LAN;
o 1 x Reset button;
o 1 x DC Jack: 12V@1.5A;
o 4x LED (5G, 2.4G, WAN, PWR);
o Ceiling mounting;
o Operational temperature: -10℃ ~ +45℃
o Size: 158mmx158mmx 28 mm
2. LED and Label
LED can be fully controlled by SW. The GbE RJ-45 is without link/active LED.
LED
Function
LED
status
LED Definition
PWR AP power / ready
status
Off
No power to AP
Green
Device ready
WAN Ethernet Network Link
Status / Activity
Off
Ethernet link unavailable
Green
Ethernet
port
link
ed
Flashing
–
Green
Ethernet activity
5G 5GHz Radio Status
Off
5G Hz radio disabled
Green
5G Hz radio enabled
2.4G 2.4GHz Radio Status
Off
2.4
G Hz radio disabled
Green
2.4
G Hz radio enabled
3. Interface Panel
WAN/PoE, LAN, DC Jack, RESET
4. Hardware feature
1- Interfaces
1
-
1
2 x GbE Port
1-1a
1 x GbE WAN with
PoE
1
x
RJ
-
45 for 10/100
/1000
M
Ethernet port;
Supports IEEE 802.3at PoE, as an isolated defined PD;
The Ethernet port shall be compatible with the physical layer interface
spec defined in 802.3 series.
Up to 100 meters of CAT5e or above cable.
1-1b 1 x GbE LAN
1
x
RJ
-
45 for 10/100
/1000
M
Ethernet port;
The Ethernet port shall be compatible with the physical layer interface
spec defined in 802.3 series.
Up to 100 meters of CAT5e or above cable.
1-2 1 x Reset Button
2mm (diameter) opening on enclosure. The reset button is connected to a
GPIO of the CPU. The behavior is controlled by software.
1
-
3
DC jack
12
V@
1.5
A DC input.
3- WIFI feature
3
-
1
Frequency
2.4GHz
2.4000GHz~2.4835GHz
5GHz
5.150~5.250, 5.250~5.350, 5.470~5.725, 5.725~5.850 GHz
3
-
2
Antenna
2 x Integrated dual
-
band antenna.
1 x BLE onboard antenna
3
-
3
Channel Rate
2.4GHz：
The device shall support the standard
channel rates:
802.11b: 1, 2, 5.5 and 11Mb/s
802.11g: 6, 9, 12, 18, 24, 36, 48 and 54Mb/s
802.11n: any combination of MCS0-MCS7, HT20 and HT40, 800ns and 400ns guard interval
802.11ac: any combination of MCS0-MCS9, HT20 and HT40, 800ns and 400ns guard interval
802.11ax: any combination of MCS0-MCS11, HE20 and HE40, 800ns and 400ns guard interval
5GHz
802.11
a:
6, 9, 12, 18, 24, 36, 48 and 54Mb/s
802.11n: any combination of MCS0-MCS7, HT20 and HT40, 800ns and 400ns guard interval
802.11ac: any combination of MCS0-MCS9; VHT20, VHT40 and VHT80; 800ns and 400ns Guard
Interval;
802.11ax: any combination of MCS0-MCS11; HE20,HE40 and HE80; 800ns and 400ns Guard Interval;
Power Control
Accuracy
The transmission power acc
uracy at the maxim power is ±2
dB
3
-
5
Frequency Tolerance
Frequency Tolerance: 802.11a/b/g/n/ac/ax：±15ppm (ambient
temperature).
3
-
6
Received maximum
input level
Shall meet IEEE requirement, that is,
(1) For 11a/g/n/ac: -20dBm of 2.4G and -30dBm of 5G @ antenna
interface.
(2) For 11b: -10dBm@ antenna interface
(3) For 11ax: -10dBm@ antenna interface
3
-
7
802.11 Features
The AP
support
concurrent operation of 2.4G and 5G.
In the worst case (one band transmission and another band
receiving), the impact to sensitivity is less than 3dB.
4- Power
4-1 AP can be powered
from 802.3 at PoE (PD)
Supports CAT
-
5
e
or above
100m
For
GE port
Power consumption
less than
18
W.
Voltage range: 50V~ 57V
PoE has the high priority than DC, if both of them are connected.
4-2
AP can be powered
from external 12V DC
input
The AP support the external AC/DC adapter with following
specification:
12 VDC nominal, +/- 5%, 1.5A
FCC/UL/CE certificated
4
-
3
Power consumption
Max 11W
5- Environment
5
-
1
Operating temperature
-
1
0
°C ~ +4
5
°C
5
-
2
Operating humidity
5% ~
9
5
% non
-
condensing
5
-
3
Storage temperature
-
4
0
°C to +
70
°C
5-4 Elevations 86kPa～106kPa
5-5 Environment
Shall be RoHS 2011/65/EU compliant (RoHS
11
compliant, no Pb);
WEEE 2002/96/EC recyclable materials requirements
5
-
6
Thermal
-
1
0
°C ~ +4
5
°C
5-7
Dustproof and
Waterproof IP30
5-8 Surge GE port with PoE support ±4KV common mode/ ±500V differential
mode surge with 10-700us / 40Ohm waveform.
5-9 ESD ±4 KV (Contact Discharge) / ±8 KV (Air Discharge)
6- Enclosure
6
-
1
Mechanical Enclosure /
Housing
6
-
2
Size
158
mm x
158
mm x
2
8
mm
6
-
3
Weight 454g
6
-
4
Mounting
Ceiling mounting
6
-
5
Material PC+ABS(fireproof)+diecast（bottom shell）
7- Reliability
7
-
1
MTBF
> 300,000 Hours
Telcordia SR-332, Reliability Prediction Procedures for Electronic
Equipment, Issue 3, Method 1, Case 3, GB/GC (Ground Benign,
Controlled) environment, 25ºC ambient temperature. Steady state,
not including software failure.
7
-
2
Service life > 5 years@ 35℃, full load.
Federal Communications Commission (FCC) Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generate, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
⚫ Reorient or relocate the receiving antenna.
⚫ Increase the separation between the equipment and receiver.
⚫ Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
⚫ Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
RF exposure warning
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment.
This equipment must be installed and operated in accordance with provided instructions and
the antenna(s) used for this transmitter must be installed to provide a separation distance of at
least 20 cm from all persons and must not be collocated or operating in conjunction with any
other antenna or transmitter.
ISED
CAN ICES-003 (B)/NMB-003(B)
Canadian Compliance Statement This device complies with Industry Canada
license-exempt RSSs. Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes:
1. l’appareil ne doit pas produire de brouillage;
2. l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, meme si
le brouillage est susceptible d’en compromettre le fonctionnement.
Caution:
1. The device for operation in the band 5150–5250 MHz is only for indoor use to
reduce the potential for harmful interference to co-channel mobile satellite
systems;
2. The high-power radars are allocated as primary users (i.e. priority users) of the
bands 5250-5350 MHz and 5650-5850 MHz and that these radars could cause
interference and/or damage to LE-LAN devices.
3. DFS (Dynamic Frequency Selection) products that operate in the bands 5250-
5350 MHz, 5470-5600MHz, and 5650-5725MHz.
Mise en garde:
1. Le dispositif destiné à être utilisé dans la bande de fréquences 5150–5250 MHz
est destiné uniquement à une utilisation en intérieur afin de réduire le risque de
brouillage préjudiciable causé par les systèmes mobiles à satellites dans le même
canal;
2. Pour les dispositifs avec une ou plusieurs antennes détachables, le gain
d'antenne maximal autorisé pour les dispositifs des bandes 5250-5350 MHz et
5470-5725 MHz doit être tel que l'équipement respecte encore les normes e.i.r.p.
limite;
3. Pour les dispositifs avec une ou plusieurs antennes détachables, le gain
d'antenne maximal autorisé pour les dispositifs de la bande 5725-5850 MHz doit
être tel que l'équipement soit toujours conforme à la norme e.i.r.p. limites, le cas
échéant.
4. Les radars à haute puissance sont attribués en tant qu'utilisateurs principaux
(utilisateurs prioritaires) des bandes 5250-5350 MHz et 5650-5850 MHz et que
ces radars pourraient causer des interférences et / ou des dommages aux
dispositifs LE-LAN.
5. Produits DFS (Dynamic Frequency Selection) fonctionnant dans les bandes de
fréquences 5250-533 MHz, 5470-5600 MHz et 5650-5725 MHz.
IMPORTANT NOTE:
Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance
20cm between the radiator and your body.
Déclarationd'exposition aux radiations:
Cetéquipementestconforme aux limitesd'exposition aux rayonnements IC établies
pour un environnement non contrôlé. Cetéquipementdoitêtreinstallé et utilisé avec un
minimum de 20cm de distance entre la source de rayonnement et votre corps.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7

ActionTec API7220 Manuel utilisateur

ActionTec
Marque
ActionTec
Modèle
API7220
Catégorie
Antennes réseau
Taper
Manuel utilisateur
Télécharger le PDF
rapport

dans d''autres langues

Autres documents