SMARTBOARD UGK-KAPPIQ-AM30-ENT Guide d'installation

Marque: SMARTBOARD

Modèle: UGK-KAPPIQ-AM30-ENT

Taper: Guide d'installation

Ce manuel convient également à

UGK-KAPPIQ-AM30-EDU

La page charge ...

www.smarttech.com/kb/170812

Tipo de Antena Marca Modelo Ganancia (dBi)

Dipole PSA RFDPA870900SBLB8G1 2400-2483.5GHz: 2.18 dBi

5725-5825GHz: 3.02 dBi

Información México La operación de este equipo está sujeta a las siguientes dos condiciones:

1 ) es posible que este equipo o dispositivo no cause interferencia perjudicial y

2) este equipo debe aceptar cualquier interferencia, incluyendo la que pueda causar su operación no deseada.

Este equipo ha sido diseñado para operar con las antenas que enseguida se enlistan y para una ganancia máxima de

antena de 2.18 dBi para 2.4 GHz/3.02 dBi para 5.8 GHz. El uso con este equipo de antenas no incluidas en esta lista o que

tengan una ganancia mayor que 2.18 dBi para 2.4 GHz/3.02 dBi para 5.8 GHz quedan prohibidas La impedancia requerida

de la antena es de 50 ohms.

Industry Canada statement:

This device complies with RSS-210 of the Industry Canada Rules. Operation is subject

to the following two conditions: (1) This device may not cause harmful interference,

and (2) this device must accept any interference received, including interference that

may cause undesired operation.

Caution:

(i) the device for operation in the band 5150-5250 MHz is only for indoor use to

reduce the potential for harmful interference to co-channel mobile satellite systems;

(ii) the maximum antenna gain permitted for devices in the bands 5250-5350 MHz

and 5470-5725 MHz shall comply with the e.i.r.p. limit; and

(iii) the maximum antenna gain permitted for devices in the band 5725-5825 MHz

shall comply with the e.i.r.p. limits specified for point-to-point and non point-to-

point operation as appropriate.

(iv) Users should also be advised that high-power radars are allocated as primary

users (i.e. priority users) of the bands 5250-5350 MHz and 5650-5850 MHz and

that these radars could cause interference and/or damage to LE-LAN devices.

Radiation Exposure Statement:

This equipment complies with IC radiation exposure limits set forth for an uncontrolled

environment. This equipment should be installed and operated with a minimum

distance of 20 cm between the antenna and all persons.

Ce dispositif est conforme à la norme CNR-210 d’Industrie Canada applicable aux appareils radio exempts de licence.

Son fonctionnement est sujet aux deux conditions suivantes: (1) le dispositif ne doit pas produire de brouillage

préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y compris un brouillage susceptible de provoquer

un fonctionnement indésirable.

Avertissement:

Le guide d’utilisation des dispositifs pour réseaux locaux doit inclure des instructions précises sur les restrictions

susmentionnées, notamment :

(i) les dispositifs fonctionnant dans la bande 5 150-5 250 MHz sont réservés uniquement pour une utilisation à l’intérieur

afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux;

(ii) le gain maximal d’antenne permis pour les dispositifs utilisant les bandes 5 250-5 350 MHz et 5 470-5 725 MHz

doit se conformer à la limite de p.i.r.e.;

(iii) le gain maximal d’antenne permis (pour les dispositifs utilisant la bande 5 725-5 825 MHz) doit se conformer

à la limite de p.i.r.e. spécifiée pour l’exploitation point à point et non point à point, selon le cas.

(iv) De plus, les utilisateurs devraient aussi être avisés que les utilisateurs de radars de haute puissance sont désignés

utilisateurs principaux (c.-à-d., qu’ils ont la priorité) pour les bandes 5 250-5 350 MHz et 5 650-5 850 MHz et que

ces radars pourraient causer du brouillage et/ou des dommages aux dispositifs LAN-EL.

Déclaration d’exposition aux radiations:

Cet équipement est conforme aux limites d’exposition aux rayonnements IC établies pour un environnement non

contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 20 cm de distance entre la source de

rayonnement et votre corps.

Federal Communication Commission interference statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device

may not cause harmful interference, and (2) this device must accept any interference received, including interference

that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of

the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used

in accordance with the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to

try to correct the interference by one of the following measures:

• Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver.

• Consult the dealer or an experienced radio/TV

technician for help

• Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected

FCC Caution: Any changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate this equipment.

Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an

uncontrolled environment. This equipment should be installed and operated with

minimum distance of 20 cm between the antenna and all persons.

NOTE: This product has been configured to operate according to the

FCC rules in the US.

This transmitter must not be co-located or operating in conjunction with any other

antenna or transmitter. 5.15–5.25 GHz frequency band operation is restricted to

indoor use only. Outdoor operations in the 5150~5250 MHz are prohibited.

smarttech.com/support

smarttech.com/contactsupport

1028711 Rev 02

smarttech.com/kb/171090

of SMART Technologies ULC in the U.S. and/or other countries. All third-party products and company names may be trademarks of their respective owners.

Contents are subject to change without notice. This product and/or use thereof covered by one or more of the following U.S. patents: smarttech.com/patents.

Other patents pending. 07/2016.

1028711

Hardware environmental compliance

SMART Technologies supports global eorts to ensure that electronic equipment is manufactured, sold and disposed of in a safe

and environmentally friendly manner.

Waste Electrical and Electronic Equipment and Battery regulations (WEEE and Battery Directives)

Electrical and electronic equipment and batteries contain substances that can be harmful to the environment and to human

health. The crossed-out wheeled bin symbol indicates that products should be disposed of in the appropriate recycling

stream and not as regular waste. See smarttech.com/compliance for more information

Batteries

The product contains a CR-2032 battery.

Recycle or dispose of batteries properly.