the user's authority to operate this equipment
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void
Such modifications could void the user's authority to operate the equipment.
66 Studios Co., Ltd is not responsible for any changes or modifications not expressly approved by 66 Studios Co., Ltd.
compromettre le fonctionnement."
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
“Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
interference that may cause undesired operation of the device.
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
This device complies with Industry Canada license-exempt RSS standard (s). Operation is subject to the following two
Industry Canada (IC) Compliance Statement for Canada
contrôlé.
Cet équipement est conforme aux limites d'exposition aux radiations de la IC définies pour un environnement non
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
— Consult the dealer or an experienced radio/TV technician for help.
— Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
— Increase the separation between the equipment and receiver.
— Reorient or relocate the receiving antenna.
try to correct the interference by one or more of the following measures:
to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
NOTE
that may cause undesired operation.
may not cause harmful interference, and (2) this device must accept any interference received, including interference
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device
Federal Communications Commission (FCC) Compliance Statement for USA
EnigmaBot
CAN ICES-3 (B)/NMB-3(B).
IC: 26754-RS0001
FCC ID: 2AYDL-RS0001
Model: EnigmaBot-E1
-
1
-
2
