To reduce the risk of fire, electric shock or injury to persons; use only insulated staples or plastic ties to secure cords, route and secure cords so that they will not be pinched or damaged

when the cabinet is pushed to the wall, position the portable cabinet light with respect to the cabinet so the lamp replacement markings are able to read during relamping. Not intended

for recessed installation or for installation in ceilings, soffits, “built-in furnishings” such as a kitchen, china cabinet or trophy case. The low voltage portable cabinet light may be installed

inside or under a kitchen cabinet or other built-in furniture when the low voltage Class 2 power supply is located outide the cabinet and is not concealed and when the line voltage power

supply cord is not concealed or run through openings in the cabinet, walls, ceilings or floors. This requirement does not apply to the wiring between the cabinet light and the power unit.

The National Electrical Code (NEC) does not permit cords to be concealed where damage to insulation may go unnoticed. To prevent fire danger, do not run cord behind walls, ceilings,

soffits or cabinets where it may be inaccessable for examination, cords should be examined periodically and immediatly replaced when any damage is noted.

le risque de feu, ne pas passer les cordons derrière les murs, plafonds, corniches et meubles où l’examen est impossible, les cordons doivent être inspectés périodiquement et remplacés

dès qu’un dommage est détecté.

Sortie module de contrôle RGB

LED tape input / Entrée Ruban DEL

Adhesive tape / Ruban adhésif

Protection tape / Protection du ruban adhésif

Connect the LED tape with the RGB control box by aligning the connector arrow with the

"+12V", then, connect the RGB control box with the LED driver, plug in the wall outlet.

Connecter le ruban DEL avec le module de contrôle RGB en alignant la flèche du connecteur

avec le "+12V", puis, connecter le module de contrôle RGB avec le transformateur DEL,

brancher dans une prise murale.

Remove the protection tape and stick the LED tape to the mounting surface.

Fix the RGB control box by using the 2 fixation holes ; make sure that there are no

obstacles between the infrared receiver and the wireless remote control.

Retirer la protection du ruban adhésif et coller le ruban DEL à la surface de montage.

Fixer le module de contrôle RGB en utilisant les deux trous de fixation ; assurez-vous qu'il

OFF ON

Included: RGB control box

with multifunction wireless

remote control.

Inclus : Module de contrôle

RGB avec manette

multi-fonctions sans-fils.