Danfoss System Manager AK-SM 810 Guide d'installation

Danfoss
Marque
Danfoss
Modèle
System Manager AK-SM 810
Taper
Guide d'installation
Instructions
System Manager
AK-SM 810
RI8SD302 2018-05
-10°< t
amb
< 55°C°
14°F < t
amb
< 130°F
0 - 95% RH, non condensing
IP20
UL: E31024
T 10
T 8
Relay 2
sm800.danfoss.com
2 Instructions RI8SD302 © Danfoss 2018/05 AK-SM 810
ADAP-KOOL®
Terminering
Termination
Terminierung
Terminaison
Terminación
Initial settings
TCP/IP
The Product contains electrical components
And may not be disposed together with domestic waste.
Equipment must be separate collected with Electrical and Elec-
tronic waste. According to Local and currently valid legislation.
Selve installationen af datakommunikationskablet skal overholde de krav, som er nævnt i dokumentet
"Datakommunikation imellem ADAP-KOOL® Køleanlægsstyringer". Litteraturnummer = RC8AC.
The actual installation of the data communication cable must comply with the requirements mentioned in the document
"Data communication between ADAP-KOOL® Refrigeration controls". Literature sheet number = RC8AC.
Beim Verlegen des Datenkommunikationskabels sind die im Dokument „Datenkommunikation zwischen ADAP-KOOL®
Kälteanlagenregelsysteme“ enthaltenen Anforderungen einzuhalten. Literaturnummer = RC8AC.
L’installation elle-même du câble de transmission de données doit respecter les contraintes citées dans le document
«Transmission de données ADAP-KOOL® Commande d’installation frigorifiques». Référence documentaire = RC8AC.
La instalación práctica del cable de comunicación de datos debe cumplir con los requisitos mencionados en el documen-
to "Comunicación de datos entre controles de refrigeración ADAP-KOOL®". Número de documento = RC8AC.
1. Check address setting = 9 (9 = Factory IP address = 192.168.1.161)
2. Download "StoreView Desktop" (sm800.danfoss.com) to PC
3. Run "StoreView Desktop"
4. Connect to 192.168.1.161
5. Set Engineering unit preferences
6. Set Users / Password
Default: User = Supervisor / Password = 12345
7. Set Communications
8. Set address setting = 0 ( 0 = master)
9. OK and Finish (reset)
Modbus
LON
Konfiguration
Configuration
Konfiguration
Configuration
Configuración
See manual: USCO.PI.R1.E9.--
LAN
Use shielded ethernet cable
If a repeater is used, make
sure the terminators
are used (included with
repeater).
Use the included 120 Ohm
terminator on last device.
  • Page 1 1
  • Page 2 2

Danfoss System Manager AK-SM 810 Guide d'installation

Danfoss
Marque
Danfoss
Modèle
System Manager AK-SM 810
Taper
Guide d'installation
Télécharger le PDF
rapport

dans d''autres langues

Documents connexes