CSCLED CLW08C LED Corn Lamp Mode d'emploi
- Taper
- Mode d'emploi
LED Corn Lamp
Instruction
1. Installation
It could be easily installed using a straight screwdriver . Use a flat-blade
screwdriver to unscrew the plug and removethe plug. And then. Choose
motion sensor to install and tighten.
Note: the motion sensor has no dialing code, and a remote control
is needed for adjustment.Please refer to the instruction for remote
control adjustment.
2. Function
Adopted dual PD technology, HB01DMS-A/B is able to differentiate artificial light
brightness from natural light after installed inside the fixture, and automatically turn off
light when ambient brightness exceeds preset lux level
Light automatically on when ambient brightness is lower than preset lux level.
With insufficient ambient brightness, light dims to 100% when motion detected.
Light dims to stand-by level if no motion detected after hold time.
Light off when ambient lux level is higher than preset lux amount.
3. Warning
DISCONNECT POWER AT SERVICE ENTRANCE BEFORE CLEANING OR
SERVICING. ADD GRILLE CURRENT TO FAN CURRENT FOR TOTAL CURRENT
DRAW. INSTALL ONLY WITH MODELS INDICATED IN THE INSTALLATION
INSTRUCTIONS.
COUPEZ L’ALIMENTATION AU PANNEAU ÉLECTRIQUE AVANT LES TRAVAUX DE
NETTOYAGE OU D’ENTRETIEN. ADDITIONNEZ LA CONSOMMATION DE COURANT
DE LA GRILLE À CELLE DU VENTILATEUR POUR OBTENIR L’APPEL TOTAL DE
COURANT. S’INSTALLE UNIQUEMENT AVEC LES MODÈLES INDIQUÉS DANS LES
DIRECTIVES D’INSTALLATION.
FCC WARING
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1)This device may not cause harmful interference.
(2)This device must accept any interference received, including interference that may
cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note:This equipment has been tested and found to comply with the limits for a class B
digital device,pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and,if not
installed and used in accordance with the instructions,may cause harmful interference to
radio communications.However,there is no guarantee that interference will not occur in a
particular installation.if this equipment does cause harmful interference to radio or
television reception,which can be determined by turning the equipment off and on,the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
-
1
-
2
