P/N 064677-002
Important 135X Information!
Contents
For Users in Canada and the United States ........................1
For Users Outside of Canada and the United States ..............2
Français.................................................................2
Deutsch .................................................................2
Italiano ..................................................................3
Español..................................................................3
For Users in Canada and the United States
Industry Canada Compliance
This digital apparatus does not exceed the Class B limits for radio emissions from digital
apparatus as set out in the radio interference regulations of Industry Canada.
Cet appareil numérique n'émet pas de bruits radioéléctriques dépassant les limites applicables
aux appareils numériques de Classe B préscrites dans le règlement sur le brouillage
radioéléctrique édicté par Industrie Canada.
Federal Communications Commission Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that can cause undesired operation.
This equipment is intended for operation in a commercial environment, in compliance with the
requirements for a Class A digital device, pursuant to Part 15 of the FCC Rules, and it must not
be used in a residential environment; however, it has also been tested and found to comply
with the more stringent requirements for a Class B device, pursuant to Part 15 of the FCC Rules.
It generates, uses, and can radiate radio frequency energy. If not installed and used in
accordance with the instruction manual, it may cause interference to radio communications. If
this equipment causes interference, the user will be required to correct the interference at the
user’s own expense.
Note: In order to maintain compliance with FCC Rules, the I/O cables that interconnect between the
device and any peripheral must be as specified by Intermec.
Caution: Changes or modifications not expressly approved by Intermec could void the user’s authority
to operate this equipment