TWO-GANG SWITCH COVER
Cubierta de Interruptor Doble
Couvercle pour Interrupteur Double
GENERAL INSTRUCTIONS
1. Turn off power.
2. Use only copper wire.
3. Use caulking around cover if not
mounted to a U.L. listed wet locations box.
4. Center cover gasket evenly.
5. Installation and wiring must comply with local electrical codes.
INSTALLATION INSTRUCTIONS
1. Connect Ground wires from supply, box, and both fixtures together
with wire connectors.
2. Connect black supply wire to switch #1 and #2 terminals. Connect
remaining switch terminals to fixture #1 and fixture #2 with separate
black wires, making sure wires are attached to the brass-colored
fixture terminal screws.
3. Connect white supply wires to remaining fixture terminals.
4. Remove cutout in gasket and place over switch.
5. Fasten switch to cover with screws provided.
6. Fasten cover to box with remaining screws.
INSTRUCCIONES AL DORSO
INSTRUCTIONS AU DOS
HUBBELL ELECTRICAL PRODUCTS
DIVISION OF HUBBELL INCORPORATED (DELAWARE)
P.O. BOX 4002 SOUTH BEND, INDIANA 46634
CANADA 870 BROCK RD. S. PICKERING, ON L1W 1Z8
MADE IN INDIA / HECHO EN INDIA / FAIT DANS L'INDE
5124-0
LISTED 22F0
FLUSH DEVICE COVER
WET LOCATIONS
LISTADA 22F0
TAPA PARA
DISPOSITIVO AL RAS
SITIOS MOJADOS
ENREGISTRER 22F0
COUVERCLE DE
DISPOSITIF AFFLEURANT
ENDROITS MOUILLÉS
With Single pole, 15A 120V
Switches
Con Dos Interruptors
Unipolar de 15 amp. 120V
Avec Deux Interrupteurs
Unipolaires de 15A 120V
0 50169 51240 1
-
1
