ATOLL ELECTRONIQUE
AV500
ATOLL ELECTRONIQUE
OWNER’S MANUAL ~ 5 CHANNEL POWER AMP.
Page 3Page 6
TECHNICAL DATA
Power Wrms/ch./8 Ω (230v):
Power Wrms/ch./4 Ω (230v):
Power supply:
Total of capacitors:
Number of Inputs:
Input Impedance:
Sensitivity:
Signal/Noise rate:
Distortion at 1kHz:
Frequency Response:
Rising Time:
Dimensions:
Weight:
5×85 W / 2×100 W
5×100 W / 2×140 W
2×340 VA
73 000 µF
2×5
47 kΩ
from 1,58 V to 1,77 V
100 dB
0,005 %
5 Hz – 200 kHz
1,3 µs
440×270×90 mm
11,0 kg
Before any cleaning, switch off your device. Use a soft and dry rag to clean up the
appliance. Never use acetone, white-spirit, ammoniac, or any kind of product containing
an abrasive agent. Never try to clean up inside the appliance.
The guarantee is two years long from the date of purchase. We recommend you to ask
your dealer to fill the guarantee and to conserve it. The guarantee is only available for
appliances that have been used correctly.
E.C. marking certified the conformity with low tension directive 73/23/CEE, directive
CEM 89/336/CEE, and national transpositions.
MAINTENANCE
GUARANTEE
E.C. MARKING
CAUTIONS
ADVISES
• To optimize the performance of your device, you should switch it
on at least half an hour before any listening, the time for the power
stage to reach its ideal working temperature.
• Your device will give you optimal listening quality after this time-
lapse.
• Between two uses, it is, therefore, preferable to let the device on so
that it remains at its optimum temperature.
• At night or when you leave your home, it is best to use the main
switch to turn off the device.
• To optimize the sound quality of your system, we recommend that
you choose good-quality connection cords. Do not hesitate to ask
your specialist dealer for advice.
• Your amplifier is equipped with a temporized switch on. A relay
protects loudspeakers on the output power stage from over-voltage.
• Do not make any connections when your device is powered on.
• Put your amplifier in a dry and well-ventilated place, far from a
source of heat.
• Avoid putting something on your amplifier.
• Strictly respect polarity + & , as well as the left and right
connections.
• Avoid any short-cut.
• Do not plug-in two speakers in parallel on the same output.