Modern Forms PD-55024 The Ring Mode d'emploi

Modern Forms
Marque
Modern Forms
Modèle
PD-55024 The Ring
Taper
Mode d'emploi
1
INSTALLATION INSTRUCTIONS
550-LED Pendant
PD-55024/55036/55048
HARDWARE
modernforms.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
CAUTION: To prevent electrical shock, ensure electricity has been turned off at the circuit breaker before beginning.
t Read all instructions before installing.
t System is intended for installation by a licensed electrician in accordance with the National Electrical Code (NEC) and local regulations.
t When handling the fixture, do not apply pressure to the LEDs. Hold the fixture by the base only.
t Retain installation instructions for future maintenance reference.
WARNING: All parts must be used as indicated in these instructions. This product is designed for use only with the supplied parts and/or
accessories designated for use by Modern Forms. Substitution of parts or accessories not designated for use with this product by Modern
Forms could result in personal injury or property damage, and will void the warranty. Contact an authorized dealer or the manufacturer if any
parts are damaged or missing.
MAINTENANCE NOTE: Coastal conditions may cause mineral and residue build-up on the fixture. We recommend that customers in coastal
areas clean all external surfaces of the fixture once every two weeks with a wet cloth.
MISE EN GARDE: Pour éviter tout choc électrique, assurez-vous que le disjoncteur soit mis hors tension avant de commencer.
t Lisez toutes les instructions avant l’installation.
t Le système doit être installé par un électricien licensié conformément au code national de l’électricité (NEC), et également aux
règlements locaux.
t Lors de la manipulation du luminaire, n’appuyez pas sur les LED. Tenez-le uniquement par la base.
ATTENTION: Toutes les pièces doivent être utilisées comme indiqué dans ces instructions. Ce produit est conçu pour être utilisé seulement
avec les pièces et/ou accessoires fournis pour être utilisés avec les produits Modern Forms. Remplacer des pièces ou accessoires non conçus
pour ce produit Modern Forms pourrait causer des dommages corporels ou matériels et pourrait également causer l’annulation de la
garantie. Veuillez contacter un revendeur autorisé ou le fabricant si des pièces manquent ou sont endommagées.
NOTE D’ENTRETIEN: Les conditions côtières peut causer une accumulation de minéraux et de résidue sur le luminaire. Nous recommendons
aux clients qui resident dans les zones côtières de nettoyer toutes les surfaces externes du luminaire une fois toutes les deux semaines avec
un chiffon humide.
Plastic anchorWood screw
$
BCD
Mounting screw
2
INSTALLATION INSTRUCTIONS
550-LED Pendant
PD-55024/55036/55048
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring Fig. 3 Back Plate Dimensions
Fig. 1
modernforms.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
PREPARATION
6KXWR͂WKHSRZHUDWWKHFLUFXLWEUHDNHUDQGUHPRYHH[LVWLQJ͇[WXUH
including the crossbar.
&DUHIXOO\XQSDFN\RXUQHZ͇[WXUHDQGOD\RXWDOOWKHSDUWVRQDFOHDU
area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
5HPRYHWKHPRXQWLQJVFUHZ%IURPWKH͇[WXUH
4. Drill holes in the wall aligned with the key holes located in the back
plate, insert the plastic anchor (D)
5. Secure back plate to the junction box using standard junction box
screws that comes with the junction box. Fasten it to the wall using
wood screw (C) onto the plastic anchor. Note: the side of the mounting
plate marked “GND” must face out.
$GMXVWWKH͇[WXUHZLUHOHQJWKE\SXVKLQJWKHFDEOHJULSSHURQWKH
canopy and pulling the wire as desired.
a. Retract these wires close to a desirable length to within the
FDQRS\EHIRUHVHFXULQJWKH͇[WXUHLQSODFH
Note: retracting or extending excessive cable length through
the cable gripper is not recommended.
b. Warning: Shortening these cables without professional helps
RUHOHFWURQLFEDFNJURXQGLVQRWDGYLVDEOH$Q\PRGL͇FDWLRQV
WRWKH͇[WXUHPD\UHVXOWLQYRLGLQJWKHZDUUDQW\RIWKHSURGXFW
CONNECTING THE WIRES (Fig. 2)
7. Connect the driver input/output wires with junction box wires as shown in Fig.2, making sure that all wire connectors (A) (C)are secured. If
\RXURXWOHWER[KDVDJUHHQRUEDUHFRSSHUJURXQGZLUHFRQQHFWWKH͇[WXUHɩVJURXQGZLUHWRLW2WKHUZLVHFRQQHFWWKH͇[WXUHɩVJURXQG
wire directly to the mounting plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
7KLV͇[WXUHIHDWXUHVHOHFWURQLFORZYROWDJH(/9RU75$,&RU9GLPPLQJFDSDELOLWLHV6HHQRWHVEHORZIRUVSHFL͇FGLPPLQJZLULQJ
information.
6HFXUHWKH͇[WXUHWRWKHEDFNSODWHXVLQJWKHPRXQWLQJVFUHZ%
NOTE: DIMMING WIRING INFORMATION (Fig. 3)
7KLV͇[WXUHIHDWXUHVHOHFWURQLFORZYROWDJH(/9RU75$,&RU9GLPPLQJFDSDELOLWLHV6HHQRWHVEHORZIRUVSHFL͇FGLPPLQJZLUHV
information.
7RXWLOL]H(/9RU75$,&GLPPLQJXVHZLUHVEODFNKRWZKLWHQHXWUDODQGEDUHFRSSHUJURXQGZLUHJURXQG
7RXWLOL]H9GLPPLQJXVHZLUHSXUSOHGLP3LQNRUJUD\GLPEODFNKRWZKLWHQHXWUDODQGEDUHFRSSHUJURXQGZLUHJURXQG
127(0DNHVXUHWRFRQQHFW9SULRUWRSRZHUXSWKH͇[WXUHLQRUGHUWRDOORZWKH9GLPPLQJWRIXQFWLRQSURSHUO\
D
C
$
B
Fixture
'ULYHU
*URXQGZLUH
Junction Box
Back plate
Plastic anchor
Wire connector
6DIHW\FRRG
363'
Junction box screw Wood screw
Mounting screw
Cable-gripper
3XVKXS
$GMXVWWKHIL[WXUHZLUHOHQJWKE\
SXVKLQJWKHFDEOHJULSSHURQ
WKHFDQRS\DQGSXOOLQJWKHZLUH
DVGHVLUHG
Žɬ
1 3/8”
1 3/4”
Pink or gray - Dim-
  • Page 1 1
  • Page 2 2

Modern Forms PD-55024 The Ring Mode d'emploi

Modern Forms
Marque
Modern Forms
Modèle
PD-55024 The Ring
Taper
Mode d'emploi
Télécharger le PDF
rapport

dans d''autres langues

Documents connexes

Autres documents