1 Rev July 26, 2021 403-216-7043 | [email protected]
MADE IN
CANADA
PROUD MEMBER OF
LETO 11/44 Mini P
Solid Stem P3Feed Suspended P2
965 SLIM CANOPY
Read and follow these
instructions before installing or
maintaining this product
Veuillez lire et suivre ces
instructions avant l’installation ou
l’entretien de ce produit
• This product is suitable for DRY INDOOR
LOCATIONS ONLY
• Make sure this product is NOT on the same
circuit as inductive loads, (e.g. fluorescent bulbs,
discharge bulbs, ventilation fans, etc...)
• Allow air to flow freely around the fixture
• Do not switch on line voltage until all wiring is
complete
• Incorrect wiring will result in irreparable damage
to LED and power supply
• This product should only be installed by a
licensed electrician
• Ce produit convient pour une installation DANS
UN ENDROIT SEC SEULEMENT
• Assurer vous que des charges inductives ne se
retrouvent pas sur le même circuit que ce produit,
(i.e. fluorescent, ampoules à décharge,
ventilateurs, etc...)
• Permettre à l’air de circuler librement autour du
luminaire
• Compléter les branchements avant de mettre
sous tension
• Un branchement incorrect créerait des
dommages irréparables à l’alimentation et au DEL
• Ce produit devrait être uniquement installé par un
électricien qualifié
Warranty
Garantie
• This product must be installed in accordance
with all applicable installation codes and
ordinance
• Limited five (5) years warranty
• Warranty is void in the eventuality of
unauthorized modifications and/or improper use
• Ce produit doit être installé conformément au
code d’installation et autres normes applicables
• Garantie limitée de cinq (5) ans
• La garantie est non valide advenant une
modification non autorisée ou un usage non
approprié
2 Rev July 26, 2021 403-216-7043 | [email protected]
MADE IN
CANADA
PROUD MEMBER OF
LETO 11/44 Mini P
Straighten feed cable, removing any bends.
5
Negative
Black/Noir
Positive
Red/Rouge
Dim Positive
Purple/Violet
Dim Negative
Grey/Gris
Make electrical connections. AC to ceiling and DC to fixture. Temperature Sensor (orange) is not used and
should be capped.
Wiring Color Code
Color/Couleur Function/Fonction
1
AC
DC
4
Secure canopy to junction box with two screws
provided. Make adjustments to cable length,
tighten cord grip cap.
2
Place driver in junction box. Screw bracket onto
junction box.
3
Line up canopy with crossbar’s screw holes, slide
onto ceiling.
Pendant: Single Feed Cable
3 Rev July 26, 2021 403-216-7043 | [email protected]
MADE IN
CANADA
PROUD MEMBER OF
LETO 11/44 Mini P
Negative
Black/Noir
Positive
Red/Rouge
Dim Positive
Purple/Violet
Dim Negative
Grey/Gris
Make electrical connections. AC to ceiling and DC to fixture. Temperature Sensor (orange) is not used and
should be capped.
Wiring Color Code
Color/Couleur Function/Fonction
5
AC
DC
7
Secure canopy to junction box with two screws
provided.
3
Place driver in junction box. Screw bracket onto
junction box.
4
Re-assemble canopy with threaded nipple
attached to the stem.
6
Line up canopy with crossbar’s screw holes, slide
onto ceiling.
Pendant: Solid Stem
1
Feed the wires through stem. Screw stem
to Leto 11 Mini head.
2
For each stem, add loctite to threads. Feed
the wires through the other stem and screw
each stem together.
-
1
-
2
-
3
dans d''autres langues
- English: luminii LETO 11 User manual
Documents connexes
-
luminii LETO 11 and 11.5 Wet Canopy Manuel utilisateur
-
-
-
-
-
-
-
-
-