Peag Dba Jlab Audio JBuds Dongle Manuel utilisateur

Taper
Manuel utilisateur
User Manual
Product name: Dongle
Product Model: JBdus Dongle
FCC ID: 2AHYV-JEDGL1
RX (receiver) to enter EMI mode, first insert receiver 1 to be tested.Open EMI Test Software
2.Click "Please click to enter EMI test" to enter the 2.402GHz frequency point, and the
interface is as follows:
3. Continue to click "Please click to enter EMI test" and change the transmission frequency to 2.439GHz
(empty carrier),
2.479GHz (empty carrier), 2.402GHz (with data), 2.439GHz (with data), 2.479GHz (with data) 16 channel
data cycle, pure receive mode, 2.402GHz (empty carrier) cycle in sequence
FCC Caution:
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
FCC ID: 2AHYB-JEDGL1
IC Caution:
RSS-Gen Issue 5 "&" RSS-Gen numéro 5
- English:
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to
the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
RF exposure statement:
The equipment complies with IC Radiation exposure limit set forth for uncontrolled
environment.
Cet appareil contient des émetteurs / récepteurs exemptés de licence conformes aux RSS
(RSS) d'Innovation, Sciences et Développement économique Canada. Le fonctionnement est
soumis aux deux conditions suivantes:
(1) Cet appareil ne doit pas causer d'interférences.
(2) Cet appareil doit accepter toutes les interférences, y compris celles susceptibles de
provoquer un fonctionnement indésirable de l'appareil.
Tout changement ou modification non expressément approuvé par la partie responsable de la
conformité pourrait annuler l'autorité de l'utilisateur à utiliser l'équipement.
Déclaration d'exposition RF:
L'équipement est conforme à la limite d'exposition aux radiations de la IC établie pour un
environnement non contrôlé.
- French:
  • Page 1 1
  • Page 2 2
  • Page 3 3

Peag Dba Jlab Audio JBuds Dongle Manuel utilisateur

Taper
Manuel utilisateur

dans d''autres langues