SUN GLOW Curved Cassette Guide d'installation
- Taper
- Guide d'installation
www.mysunglow.com
Roller Shade - Curved Cassette &
Compact Curved Cassette
Installation Instructions
Installation Instructions | Vision | 2022-04-29 1 of 2
Vision Roller Shade System
Installation Instructions
WARNING MISE EN GARDE
STRANGULATION HAZARD — Young children
can be strangled by cords. Immediately remove this
product if a cord longer than 22 cm or a loop
exceeding 44 cm around becomes accessible.
RISQUE D’ÉTRANGLEMENT — Les enfants en bas
âge peuvent s’étrangler avec des cordes. Enlevez
immédiatement ce produit si une corde mesurant
plus de 22 cm devient accessible ou si le contour
d’une boucle de plus de 44 cm devient accessible.
1BRACKET POSITION
Fully assembled & tested: Taking any Vision™ roller shade apart for any reason will void the warranty.
V84 Standard
MIN Distance = ¹⁄4”
MAX Distance = 1¹⁄4”
V102 Standard
MIN Distance = ¹⁄4”
MAX Distance = 1”
V84 Flex
MIN Distance = ¹⁄4”
MAX Distance = 1”
• Each Vision™ Roller Shade System comes
standard with two mounting brackets.
• It is important that the brackets be securely
mounted, level, and aligned to each other.
Shimming may be required.
2INSTALL MOUNTING BRACKETS
Attach Flex Mounting Brackets using two #8x1.5” Pan Head Zinc Screws included or equivalent, depending on the surface type.
Ensure all screws should be securely fastened to a sturdy structure. For outside wall mounted applications, a spacer plate
might be required.
V84 STANDARD & V102 STANDARD
Ceiling Mount Wall Mount Lateral Mount
Screw Head
Zone
V84 FLEX
Ceiling Mount Wall Mount
www.mysunglow.com
Installation Instructions | Vision | 2022-04-29 2 of 2
3INSTALL VISIONTM ROLLER SHADE SYSTEM
With the Front Fascia facing you, insert the front edge of the Assembly Bracket onto the front lip of each Flex Mounting Bracket,
push upward and back until the back edge of the Assembly Bracket snaps into the bottom tab of the Flex Mounting Bracket.
Repeat this process for each bracket.
V84 FLEX V84 FLEX
Open Position Open Position
Back
Front
Front Edge
Snap
Closed Position Closed Position
4LEVELING THE SHADE
Direction
Adjustment Screw: Insert #0
Robertson or Small Flat Head
To adjust shade level if window is not square, follow the steps below.
Turn the small Adjustment Screw on the Adjustable End Bracket either
clockwise to raise the shade or counter clockwise to lower the shade
until the shade is level.
5INSTALL THE SAFETY SHIELD
NOTE: For shades with chain operation only.
Ensure that Safety Shield is carefully and properly installed.
-
1
-
2
