Halco SDL6-15-CS-MS Guide d'installation

Taper
Guide d'installation
LED 6” Surface Downlight Installation
Instructions- Model 82996
®
Please read carefully and save these instructions,
as you may need them at a later date.
1.INSTALLATION OR ASSEMBLY INSTRUCTIONS
WIRING INSTRUCTIONS THAT SPECIFY THE PROPER
METHOD OF CONNECTING THE GROUNDING MEANS AND
MAINTAINING POLARITY SHALL BE INCLUDED WITH THE
LUMINAIRE IN A MANNER THAT WILL REQUIRE THE
INSTALLER TO HANDLE THE INSTRUCTIONS DURING
INSTALLATION.
2."THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE
WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF
THE PRODUCT AND THE HAZARDS INVOLVED" and "CE
PRODUIT DOIT ETRE INSTALLE SELON LE CODE
D'INSTALLATION PERTINENT, PAR UNE PERSONNE QUI
CONNAi BIEN LE PRODUIT ET SON FONCTIONNEMENT AINSI
QUE LES RISQUES INHERENTS«
3."CONSUL TA QUALIFIED ELECTRICIAN TO ENSURE
CORRECT BRANCH CIRCUIT CONDUCTOR" and "CONSULTER
UN ELECTRICIEN QUALIFIE POUR VOUS ASSURER QUE LES
CONDUCTEURS DE LA DERIVATION SONT ADEQUATS"
WARNING- RISK OF FIRE OR ELECTRIC SHOCK
•DO NOT MAKE OR ALTER ANY OPEN HOLES IN AN ENCLOSURE
OF WIRING OR ELECTRICAL COMPONENTS DURING LAMP
INSTALLATION.
•TO PREVENT WIRING DAMAGE OR ABRASION, DO NOT
EXPOSE WIRING TO EDGES OF SHEET METAL OR OTHER
SHARP OBJECTS.
•SUITABLE FOR WET LOCATIONS.
•SUITABLE FOR TYPE IC OR SUITABLE FOR TYPE NON-IC.
•THIS DEVICE IS NOT INTENDED FOR USE WITH EMERGENCY
EXITS.
ASSEMBLY AND INSTALL ATION
This IC/AT fixture is intended for use in suspended
ceilings(with or without insulation).
1.Shut off the power before installation.
2.Remove the Lens by turning it counter clockwise (FIG.1)
3.Adjust the color to desired one,by sliding the selector switch. (FIG.2)
4.Connect the wires: Black to Black, White to White, Green to Green. Secure the
connection with Wire Nuts.
Tuck all the wires into the Outlet box.(FIG.3)
5.Align two holes in the fixture with Outlet box. Use screws to attach one to another.
Do not over tighten. (FIG.4)
6.Place the Lens back and turn it clockwise to fix.(FIG.5)
7.Complete the installation by pushing the fixtures into the ceiling. Caulk the space
between the wall and the Shell. (FIG.6)
LED 6” Surface Downlight Installation
Instructions- Model 82996
®
  • Page 1 1
  • Page 2 2

Halco SDL6-15-CS-MS Guide d'installation

Taper
Guide d'installation

dans d''autres langues