Ignis AKL 752/WH Mode d'emploi

AKL 752/WH
Ignis
Marque
Ignis
Modèle
AKL 752/WH
Taper
Mode d'emploi
5019 619 61831/B 5019 619 61831/B
RIFERIMENTI NORMATIVE
NAZIONALI
Norma di areazione della stanza
Nota:
Quando l’apparecchio non è provvisto di
sicurezza sui bruciatori del piano di lavoro
(termocoppie), le aperture di ventilazione devono
essere maggiorate nella misura del 100% con un
minimo di 200 cm
2
, in conformità al D.M. 21 aprile
1993.
Collegamento all’alimentazione del gas
Prima di procedere al collegamento
dell’apparecchio, accertarsi che l’impianto di
alimentazione sia conforme alle norme
UNI-CIG 7129
e
UNI CIG 7131
.
Allacciamento al gas
Per il collegamento dell’apparecchio alla rete del gas o
bombola, utilizzare il tubo metallico rigido di rame o
acciaio con relativi raccordi conformi alla norma
UNI-CIG 7129
, oppure il tubo flessibile in inox con
parete continua conforme alla norma
UNI-CIG 9891
.
I tubi metallici flessibili devono avere una lunghezza
massima di 2 m.
I regolatori di pressione da utilizzare devono essere
conformi alla norma
UNI EN 12864
per gas in
bombola e
UNI EN 88
per gas canalizzati (metano
di rete).
RAPPELS SUR LES NORMES
DE SÉCURITE EN VIGUEUR
DANS LE PAYS
D’INSTALLATION
L’appareil est équipé d’un embout conique fileté 1/2”
pour être raccordé à l’alimentation en gaz
(conformément aux réglementations
ISO 7/1 RP 1/2
).
Le raccordement doit être réalisé conformément à
la norme
NBN D 51-003
au moyen d’un tuyau
rigide, ou conformément au document des
spécifications
A.R.G.B./03
à l’aide d’un tuyau
flexible.
Au moment de l’installation, l’appareil doit être doté
d’une valve d’arrêt
agréée AGB
.
REFERENCE TO LOCAL
REGULATIONS: ENGLISH
VERSION FOR IT
REGULATION
Regulation for room ventilation
Note:
If the appliance is not equipped with safety
devices on the burners (thermocouples), the air vents
must be increased by 100%, and must be at least
200 cm
2
), in compliance with M.D. 21 April 1993.
Connection to gas supply
Before connecting the appliance, make sure that the
gas supply system complies with standards
UNI-CIG 7129
and
UNI CIG 7131
.
Gas connection
The connection to the mains gas network or gas
cylinder must be made using a rigid copper or steel
pipe with fittings complying with standards
UNI-CIG 7129
, or using a continuous-surface
stainless steel hose complying with standards
UNI-CIG 9891
.
The maximum length of the hose is 2 m.
The pressure control valves to be used must comply
with the
UNI EN 12864
standard for gas cylinders
and the
UNI EN 88
standard for piped methane gas.
NATIONALER
NORMENBEZUG
Das Gerät ist mit einem konischen Gewinde
(1/2 Zoll) für den Gasanschluss ausgerüstet
(gemäß
ISO 7/1 RP 1/2
).
Der Gasanschluss muss gemäß
NBN D
51-003
mit einer starren Leitung oder entsprechend
dem Spezifikationsblatt
A.R.G.B./03
mit einem
flexiblen Schlauch erfolgen.
Das Gerät muss mit einem nach
AGB
zugelassenen
Notstoppventil ausgerüstet sein.
IT
BE
IT
BE
REFERENTIES LOKALE
VOORSCHRIFTEN
Het apparaat is uitgerust met een kegelvormig 1/2”
uiteinde met schroefdraad voor de aansluiting op de
gastoevoer (overeenkomstig de ISO-voorschriften
ISO 7/1 RP 1/2
).
De aansluiting moet uitgevoerd worden ofwel met
een stijve leiding in overeenstemming met de norm
NBN D 51-003
ofwel met een flexibele leiding in
overeenstemming met het specificatieblad
A.R.G.B./03
.
Het apparaat moet geïnstalleerd worden met een
door
AGB goedgekeurde
afsluiter.
REFERENCE TO LOCAL
REGULATIONS: ENGLISH
VERSION FOR BE REGULATION
The appliance is supplied with a 1/2” threaded conical
end to be connected to the gas supply (according to ISO
regulations
ISO 7/1 RP 1/2
).
The connection must be effected in accordance with
standard
NBN D 51-003
using rigid piping or in
accordance with specifications sheet
A.R.G.B./03
using flexible tubing.
The appliance must be installed complete with an
AGB-approved
stop valve.
REFERENCE TO LOCAL
REGULATIONS
Provision for ventilation
The room in which the appliance is installed must
have an air supply to current
B.S. 5440 - Part 2
standards.
All rooms require a permanent vent in addition to
the openable window.
If there are other fuel burning appliances in the same
room
B.S. 5440 - Part 2
should be consulted to
determine the air vent requirements.
If the appliance is installed in a cellar or basement, it
is advisable to provide an air vent of 65 cm,
irrespective of the room volume.
Gas Safety Regulations
The law requires that all gas appliances are installed
by competent persons in accordance with the
current gas safety regulations. Failure to install
appliances correctly may lead to prosecution.
It is in your own interest, and that of safety, to ensure
that the law is complied with. The hob should be
installed in accordance with the
Gas Safety
(Installation and Use) Regulations,
the
Building
Regulations
issued by the Department of the
Environment and the
Building Standard
(Scotland)
(Consolidation) Regulations,
issued
by the Scottish Development Department.
In the G.B.,
CORGI
registered installers work to
safe standards of practice.
RAPPELS SUR LES NORMES DE
SÉCURITE EN VIGUEUR DANS
LE PAYS D’INSTALLATION
L’installation et la maintenance de l’appareil doivent
être effectuées par un technicien qualifié qui travaille
en conformité avec les réglementations en vigueur,
et tout particulièrement :
- Décret du 2 août 1977
Règles techniques et de sécurité applicables aux
installations fonctionnant au gaz et au gaz
d’hydrocarbures liquéfiés situées à l’intérieur
d’immeubles résidentiels et des dépendances.
REFERENCE TO LOCAL
REGULATIONS: ENGLISH
VERSION FOR FR
REGULATION
The installation and maintenance of the appliance
must be carried out by a qualified skilled technician
in accordance with the regulations in force, and in
particular:
- Decree of 2 August 1977
Technical and Safety Rules applicable to fuel gas and
liquefied hydrocarbon installations located within
residential buildings and outbuildings.
BE
BE
GB
FR
FR
5019 619 61831/B
- Standard DTU P 45 - 204
Installations au gaz (anciennement DTU no. 61-1 -
Installations au gaz avril 1982 + supplément no. 1
de juillet 1984).
- Réglementations du ministère de la santé.
Pour les appareils raccordés à l’alimentation
électrique principale.
- Standard NF C 15-100
Installations électriques basse tension - Standards.
- Standard DTU P 45 - 204
Gas installations (formerly DTU no. 61-1 - Gas
installations April 1982 + supplement no. 1
of July 1984).
- Departmental Health Regulations
For appliances connected to the mains electricity
supply.
- Standard NF C 15-100
Low-voltage electrical installations - Standards.
NATIONALER
NORMENBEZUG
Gas-Sicherheitsbestimmungen
Es ist vorgeschrieben, dass alle Gasgeräte nur durch
konzessionierte Gasinstallateure installiert und
angeschlossen werden. Die Installation muss
entsprechend den
TRGI
(Technische Regeln
Gasinstallation) sowie den
TRF
(Technische Regeln
Flüssiggas) erfolgen.
Die Folgen von fehlerhaften Installationen der Geräte
können strafrechtlich geahndet werden.
In ihrem eigenen Interesse und zu ihrer eigenen
Sicherheit sollten Sie für die Einhaltung dieser
Vorschrift Sorge tragen.
REFERENCE TO LOCAL
REGULATIONS: ENGLISH
VERSION FOR DE REGULATION
It is law that all gas appliances are installed and
connected to the gas supply by authorised
technicians. The installation must be performed in
accordance with the
TRGI
(technical regulations for
gas connection) and/or
TRF
(technical regulations for
liquid gas).
Failure to install appliances correctly could lead to
prosecution. It is in your own interest, and that of
safety, to ensure that the law is complied with.
REFERENCIA A LA
NORMATIVA LOCAL
Las instalaciones de gas para cocinas domesticas
deberan atenerse a las
NORMAS DE
INSTALACIONES DE GAS EN EDIFICIOS
HABITADOS,
publicadas en el
B.O.E. N° 77
de
fecha 30 de Marzo de 1974.
REFERENCE TO LOCAL
REGULATIONS: ENGLISH
VERSION FOR ES REGULATION
Gas installations for household cookers must comply
with the
REGULATIONS ON GAS
INSTALLATIONS IN INHABITED
BUILDINGS,
published in the
B.O.E.
(Official
State Gazette) No. 77
, of March 30, 1974.
REFERENTIES LOKALE
VOORSCHRIFTEN
De installatie moet worden uitgevoerd volgens de norm
NBN D 51-003
.
REFERENCE TO LOCAL
REGULATIONS: ENGLISH
VERSION FOR NL REGULATION
Installation must be performed in accordance with
standard
NBN D 51-003
.
DE
DE
ES
ES
NL
NL
  • Page 1 1
  • Page 2 2

Ignis AKL 752/WH Mode d'emploi

AKL 752/WH
Ignis
Marque
Ignis
Modèle
AKL 752/WH
Taper
Mode d'emploi
Télécharger le PDF
rapport

dans d''autres langues

Autres documents