SMART Technologies iQ experience Guide d'installation

Taper
Guide d'installation

Ce manuel convient également à

SBID-6xxx ..........................3
SBID-7xxx
..........................5
UGK-AM50
1 2
3
4 5
A
B
1031493 Rev 03 3
SBID-6xxx
SBID-6xxx
T 10
#2
Congratulations on your new SMART product!
smarttech.com/downloads - Download software
smarttech.com/support - Information on support, compliance,
warranty, and product registration
Willkommen in Ihrem neuen SMART-Produkt!
smarttech.com/downloads - Laden Sie Ihre Software herunter
smarttech.com/support - Informationen über Support, Compliance,
Garantie und Produktregistrierung
Félicitations pour votre nouveau produit SMART !
smarttech.com/downloads - Télécharger votre logiciel
smarttech.com/support - Informations sur l'assistance, la conformité,
la garantie et l'enregistrement du produit
SMART Technologies
3636 Research Road NW
Calgary, AB, T2L 1Y1
CANADA
Toll free (U.S./CA): 1.888.42.SMART
Tel: +1.403.245.0333
P/N: 1029266 Rev: 02
T 10
6
7
8
4 1031493 Rev 03
9
10 11
Installation and maintenance guide
1031493 Rev 03 5
SBID-7xxx
1 2
Audio S/PDIF Audio VGA HDMI 1 DisplayPort Service Ethernet
Out Out In
3
A
B
SBID-7000
SBID-7200
4 5
SBID-7xxx
T 10
#2
Congratulations on your new SMART product!
smarttech.com/downloads - Download software
smarttech.com/support - Information on support, compliance,
warranty, and product registration
Willkommen in Ihrem neuen SMART-Produkt!
smarttech.com/downloads - Laden Sie Ihre Software herunter
smarttech.com/support - Informationen über Support, Compliance,
Garantie und Produktregistrierung
Félicitations pour votre nouveau produit SMART !
smarttech.com/downloads - Télécharger votre logiciel
smarttech.com/support - Informations sur l'assistance, la conformité,
la garantie et l'enregistrement du produit
SMART Technologies
3636 Research Road NW
Calgary, AB, T2L 1Y1
CANADA
Toll free (U.S./CA): 1.888.42.SMART
Tel: +1.403.245.0333
P/N: 1029266 Rev: 02
Audio
Out
Audio
Out
6
7
8
Audio S/PDIF
Out Out
6 1031493 Rev 03
9
10
Installation and maintenance guide
11
1031493 Rev 03 7
Innovation, Science and Economic Development Canada:
This device complies with RSS-247 of the ISED rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Caution:
(i) the device for operation in the band 5150-5250 MHz is only for indoor use
to reduce the potential for harmful interference to co-channel mobile satellite
systems;
(ii) the maximum antenna gain permitted for devices in the bands 5250-5350
MHz and 5470-5725 MHz shall comply with the e.i.r.p. limit; and
(iii) the maximum antenna gain permitted for devices in the band 5725-5825 MHz
shall comply with the e.i.r.p. limits specified for point-to-point and non point-to-
point operation as appropriate.
(iv) Users should also be advised that high-power radars are allocated as primary
users (i.e. priority users) of the bands 5250-5350 MHz and 5650-5850 MHz
and that these radars could cause interference and/or damage to LE-LAN
devices.
Radiation Exposure Statement:
This equipment complies with ISED radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20 cm between the antenna and all persons.
Cet appareil est conforme à la norme ISED CNR-247 pour les appareils radio agréés.
Son fonctionnement est sujet aux deux conditions suivantes: (1) le dispositif ne doit pas
produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y
compris un brouillage susceptible de provoquer un fonctionnement indésirable.
Avertissement:
Le guide d’utilisation des dispositifs pour réseaux locaux doit inclure des instructions précises
sur les restrictions susmentionnées, notamment :
(i) les dispositifs fonctionnant dans la bande 5 150-5 250 MHz sont réservés uniquement
pour une utilisation à l’intérieur afin de réduire les risques de brouillage préjudiciable aux
systèmes de satellites mobiles utilisant les mêmes canaux;
(ii) le gain maximal d’antenne permis pour les dispositifs utilisant les bandes 5 250-5 350
MHz et 5 470-5 725 MHz doit se conformer à la limite de p.i.r.e.;
(iii) le gain maximal d’antenne permis (pour les dispositifs utilisant la bande 5 725-5 825
MHz) doit se conformer à la limite de p.i.r.e. spécifiée pour l’exploitation point à point et
non point à point, selon le cas.
(iv) De plus, les utilisateurs devraient aussi être avisés que les utilisateurs de radars de haute
puissance sont désignés utilisateurs principaux (c.-à-d., qu’ils ont la priorité) pour les
bandes 5 250-5 350 MHz et 5 650-5 850 MHz et que ces radars pourraient causer du
brouillage et/ou des dommages aux dispositifs LAN-EL.
Déclaration d’exposition aux radiations:
Cet équipement est conforme aux limites d’exposition aux rayonnements ISED établies
pour un environnement non contrôlé. Cet équipement doit être installé et utilisé avec un
minimum de 20 cm de distance entre la source de rayonnement et votre corps.
Federal Communication Commission interference statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (
2) this device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/ TV technician for help
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
EUROPE
EU Declaration of Conformity
Hereby, SMART Technologies ULC declares that the radio equipment type OPS, AM50 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of confor-
mity is available at the following internet address: www. smarttech.com/compliance
The frequency band and the maximum transmitted power in EU are: • 2400MHz – 2483.5MHz: 19dBm (EIRP)
• 5150MHz – 5350MHz: 16dBm (EIRP)
• 5470MHz – 5725MHz: 16dBm (EIRP)
Restrictions in AT/BE/BG/CZ/DK/EE/FR/DE/IS/IE/IT/EL/ES/CY/LV/LI/LT/LU/HU/MT/NL/NO/PL/PT/RO/SI/SK/TR/FI/SE/CH/UK/HR. 5150MHz-5350MHz is for indoor use only.
Caution: Exposure to Radio Frequency Radiation This equipment complies with EU radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20 cm between the radiator and your body.
support.smarttech.com
support.smarttech.com/contact-support
FCC Caution: Any changes or modifications not expressly
approved by the party responsible for compliance could void the
user’s authority to operate this equipment.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance of 20 cm between
the antenna and all persons.
NOTE: This product has been configured to operate according
to the FCC rules in the US.
This transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter. 5.15–5.25 GHz frequency
band operation is restricted to indoor use only. Outdoor operations
in the 5150~5250 MHz are prohibited.
1031493 Rev 03
© 2019 SMART Technologies ULC. All rights reserved. SMART Board, smarttech, the SMART logo and all SMART taglines are
trademarks or registered trademarks of SMART Technologies ULC in the U.S. and/or other countries. All third-party products and
company names may be trademarks of their respective owners. Contents are subject to change without notice. This product and/or
use thereof covered by one or more of the following U.S. patents: smarttech.com/patents. Other patents pending. 10/2019.
*1031493*
kb 171294
Hardware environmental compliance
SMART Technologies supports global eorts to ensure that electronic equipment is manufactured, sold and disposed of in a safe and environmentally friendly manner.
Waste Electrical and Electronic Equipment and Battery regulations (WEEE and Battery Directives)
Electrical and electronic equipment and batteries contain substances that can be harmful to the environment and to human health. The crossed-out wheeled bin symbol
indicates that products should be disposed of in the appropriate recycling stream and not as regular waste. See smarttech.com/compliance for more information.
Batteries The product contains a CR-2032 battery. Recycle or dispose of batteries properly.
Perchlorate material Battery contains perchlorate material. Special handling may apply. See dtsc.ca.gov/hazardouswaste/perchlorate.
+
-
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

SMART Technologies iQ experience Guide d'installation

Taper
Guide d'installation
Ce manuel convient également à

dans d''autres langues