WAC Lighting

www.waclighting.com

Phone (800) 526.2588 • Fax (800) 526.2585

Headquarters/Eastern Distribution Center

44 Harbor Park Drive • Port Washington, NY 11050

Phone (516) 515.5000 • Fax (516) 515.5050

Western Distribution Center

1750 Archibald Ave • Ontario, CA 91761

Phone (800) 526.2588 • Fax (800) 526.2585

WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. AUGUST, 2014

INSTALLATION INSTRUCTION

Paloma - 523 LED Adjustable Beam

WTK-LED523, WHK-LED523

WARNING

IMPORTANT: NEVER attempt any work without shutting o the electricity.

AVERTISSEMENT

IMPORTANT : Coupez l’électricité avant TOUTE manipulation.

- Lisez toutes les instructions avant d’installer.

- Système est destiné à être installé par un électricien qualié en conformité avec le code national de l’électricité et les

règlements locaux.

- Accédez au panneau central de disjoncteurs ou de fusibles de votre demeure et placez l’interrupteur principal en

position d’arrêt (« OFF »).

- Placez l’interrupteur mural en position d’arrêt (« OFF »).

All parts must be used as indicated in these instructions. Do not substitute any parts, leave parts out, or use any parts that are

worn out or broken. Failure to follow this instruction may invalidate the ETL/CETL listing of this xture.

1. Make sure that the lock switch is in the unlock position and

the circuit selection handle is in the o position. (See Figure 1)

2. Align the alignment tab bump on the adapter with

the groove/slot on the track (see Figure 2).

Once aligned, insert adapter into the track.

Figure 1

Track

Adapter

Lock switch

(Unlock position)

WAC Lighting

www.waclighting.com

Phone (800) 526.2588 • Fax (800) 526.2585

Headquarters/Eastern Distribution Center

44 Harbor Park Drive • Port Washington, NY 11050

Phone (516) 515.5000 • Fax (516) 515.5050

Western Distribution Center

1750 Archibald Ave • Ontario, CA 91761

Phone (800) 526.2588 • Fax (800) 526.2585

WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. AUGUST, 2014

3. To secure the xture to the track turn the lock

switch to its locked position. (See Figure 3)

4. Select the circuit you want the luminaire to be powered

on by rotating the circuit selection handle

to circuit 1 or 2. (See View A)

5. Switch the main fuse breaker and circuit breaker to “ON” position.

horizontally and vertically to aim it properly. (See Figure 4)

8. Rotate beam adjusting knob until desired beam is achieved -

clockwise for smaller beam, and counter clockwise

for larger beam. (See Figure 5)

Figure 3

View A

Figure 4

Figure 5

INSTALLATION INSTRUCTION

Paloma - 523 LED Adjustable Beam

WTK-LED523, WHK-LED523