Feit 74006/6WYCA Manuel utilisateur

Marque: Feit

Modèle: 74006/6WYCA

Taper: Manuel utilisateur

FEIT ELECTRIC COMPANY | PICO RIVERA, CA | www.feit.com

74006/6WYCA

Questions, problems, missing parts?

Before returning to store, visit feit.com/help for further assistance.

USE AND CARE GUIDE

7.5 INCH DIMMABLE WHITE ROUND CEILING DOWNLIGHT

WITH SELECTABLE COLOR

2 WWW.FEIT.COM

Retain this manual for future use.

Table of Contents

Table of Contents ................................................................................................. 2

Safety Information ................................................................................................ 2

Warranty ........................................................................................................ 2

Pre-Installation .................................................................................................. 3

Tools Required .................................................................................................. 3

Hardware Included .............................................................................................. 3

Installation .....................................................................................................4-6

Changing the Color Settings ........................................................................................ 7

Safety Information

For your safety, always remember to:

□Turn off the power supply at the fuse or circuit breaker box

before you install the ﬁxture.

□Ground the ﬁxture to avoid potential electric shock and

to ensure reliable starting.

□Double-check all connections to be sure they are

tight and correct.

□Wear rubber soled shoes and work on a sturdy

wooden ladder.

□Account for small parts and destroy packing material, as these

may be hazardous to children.

This ﬁxture is designed for use in a circuit protected by a fuse or

circuit breaker. It is also designed to be installed in accordance with

local electrical codes. If you are unsure about your wiring, consult a

certiﬁed electrician or local electrical inspector, and check your local

electrical code.

WARNING: RISK OF ELECTRIC SHOCK. House electric current can

cause painful shock or serious injury unless handled properly.

CAUTION: Turn off the main power at the circuit breaker before

installing the ﬁxture, in order to prevent possible shock.

WARNING: To prevent wiring damage or abrasion, do not expose

wiring to edges of sheet metal or other sharp objects.

Limited Warranty

This product is warrantied to be free from defects in workmanship and materials for up to 5 years from date of purchase.If the product fails within the warranty period, please

contact Feit Electric at[email protected], visit feit.com/contact-us or call 1-866-326-BULB (2852) for instructions on replacement or refund.REPLACEMENT OR REFUND IS YOUR

SOLE REMEDY.EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ANY IMPLIED WARRANTIES ARE LIMITED IN DURATION TO THE DURATION OF THIS WARRANTY. LIABILITY

FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES IS HEREBY EXPRESSLY EXCLUDED. Some states and provinces do not allow the exclusion of incidental or

consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you speciﬁc legal rights, and you may also have other rights

which vary from state to state or province to province.which vary from state to state or province to province.

FCC STATEMENT

This device complies with part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation. Note: This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not occur

in a particular installation. If this equipment does cause harmful interference to radio

or television reception, which can be determined by turning the equipment off and on,

the user is encouraged to try to correct the interference by one or more of the following

measures: Reorient or relocate the receiving antenna. Increase the separation between

the equipment and receiver. Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected. Consult the dealer or an experienced

radio/TV technician for help. Any changes or modiﬁcations not expressly approved by

the manufacturer could void the user’s authority to operate the equipment. Feit Electric

Company, 4901 Gregg Road, Pico Rivera, CA 90660. www.feit.com. CAN ICES-005 (B).

WARNING: Risk of ﬁre. Use only on 120 volt 60Hz circuits. Suitable

for damp locations. Before installing your lighting ﬁxture, thoroughly

review enclosed installation manual. If you do not have sufﬁcient

electrical wiring experience, please refer to a do-it-yourself wiring

handbook or have your ﬁxture installed by a certﬁed electrician.

All electrical connections must be in accordance with Local and

National Electrical Code (NEC) Standards. Reliable operating

temperature is 0˚F –120˚F. If ﬂickering occurs in low level dimming,

increase light level. Compatible with most dimmers including

Leviton 6681-IW, Lutron S-600P and Lutron DVCL-153. Dimmable to

10% with most dimmers.

NOTICE: All electrical connections must be in accordance with local and

National Electrical Code (N.E.C.) standards. If you are unfamiliar with proper

electrical wiring connections obtain the services of a certiﬁed electrician.

Install this kit only in luminaires that have the construction features and

dimensions shown in the photographs and/or drawings and where the input

rating of the retroﬁt kit does not exceed the input rating of the luminaire.

Remove the ﬁxture and the mounting package from the box and make sure

that no parts are missing by referencing the illustrations on the installation

instructions. Do not make or alter any open holes in an enclosure of wiring or

electrical components during kit installation.

THE RETROFIT KIT IS ACCEPTED AS A COMPONENT OF A LUMINAIRE WHERE THE

SUITABILITY OF THE COMBINATION SHALL BE DETERMINED BY AUTHORITIES

HAVING JURISDICTION

Supplier’s Declaration of Conformity:

47 CFR § 2.1077 Compliance Information

Responsible Party: Feit Electric Company

4901 Gregg Road, Pico Rivera, CA 90660, USA 562-463-2852

Unique Identiﬁer: 74006/6WYCA

THIS DEVICE IS NOT INTENDED FOR USE WITH EMERGENCY EXITS

3 WWW.FEIT.COM

Pre-Installation

TOOLS REQUIRED

HARDWARE INCLUDED

NOTE: Hardware not shown to actual size.