5026-0
GENERAL INSTRUCTIONS
IMPORTANT: Mount cover with hinge
on top.
1. Turn off power.
2. Use only copper wire.
3. Remove appropriate device cutout on
gasket.
4. Center cover gasket evenly.
5. Install mounting screws(provided).
6. Use caulking around cover if not
mounted to a U.L. listed wet locations
box.
7. Installation and wiring must comply
with local electrical codes.
NOTE: If mounting to box, drill out
(4) 5/32" holes in drill spots on plate
before assembly.
INSTRUCCIONES AL DORSO
INSTRUCTIONS AU DOS
RAYNTITE
®
SINGLE-GANG DEVICE COVER
Cubierta de Perforación
Sencilla Rayntite
®
Couvercle pour Boîte
Simple Rayntite
®
HUBBELL ELECTRICAL PRODUCTS
DIVISION OF HUBBELL INCORPORATED (DELAWARE)
P.O. BOX 4002 SOUTH BEND INDIANA 46634
CANADA 870 BROCK RD. S. PICKERING, ON L1W 1Z8
MADE IN INDIA / HECHO EN INDIA / FAIT AU INDIA
LISTED 731A
FLUSH DEVICE COVER
WET LOCATIONS
WITH COVER CLOSED
LISTADA 731A
TAPA PARA
DISPOSITIVO AL RAS
SITIOS MOJADOS CON
LA TAPA CERRADA
ENREGISTRER 731A
COUVERCLE DE
DISPOSITIF AFFLEURANT
ENDROITS MOUILLÉS SI
LE COUVERCLE EST FERMÉ
One Single Receptacle 1.593"
Una tomacorriente Un ca
de 1.593"
Une prise Simple 1.593po
-
1
dans d''autres langues
- English: Bell 5026-0 Installation guide
Documents connexes
-
Bell 5175-1 Guide d'installation
-
-
-
-
-
-
-
-
-
