EN
KODAK USB Power Pack
KP1850
User Guide
The KP1850 is a rechargeable Li-Ion power pack ideal for
charging and powering MP3 players, cell phones, digital
cameras, and portable gaming systems via a USB cable.
Approximate additional run/talk time (results vary by
device):
• MP3 players ≤ 60 hours
• Cell phones ≤ 9 hours
• Smart phones ≤ 4.5 hours
Operation
1. Charge the KP1850 before first use. To charge, plug it
into a power outlet. Charging takes up to 5 hours.
Note: Maximum cycle life is obtained by shallow
discharge and charge conditions; bring to a full charge
regularly.
2. Connect the
included micro USB
to USB cable to
both the KP1850
and your USB
device. You can
connect a second
device using the
cable that came
with the device.
IMPORTANT:
For APPLE mobile digital devices, use the USB cable that
came with your device.
Unplug the cable(s) when not in use to conserve power in
the KP1850.
Specifications
Voltage 100-240 V, 50/60 Hz
Input Current 100 mA maximum
Output Current 1000 mA maximum
USB Output 5 V + 0.35 V; -0.0 V
Storage -4 to 86° F (-20 to 30° C)
Operation 32 to 113° F (0 to 45° C)
IMPORTANT SAFETY
INSTRUCTIONS—Save These Instructions
• DANGER—TO REDUCE THE RISK OF FIRE OR
ELECTRICAL SHOCK, CAREFULLY FOLLOW THESE
INSTRUCTIONS.
• CAUTION: Keep dry. Do not use extension cords with
this product. Do not operate if it has been subjected to
electrical or physical shock or other damage. Do not
disassemble product.
• This product is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning the use of the product by a person responsible
for their safety.
• Children should be supervised to ensure that they do
not play with the product.
• It is normal for batteries to become warm while
charging.
Support
www.kodak.com/go/support
www.kodak.com/go/contact
Regulatory Information
FCC compliance and advisory
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired operation.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed or used in accordance
with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning
the equipment o and on, the user is encouraged to try to
correct the interference by one or more of the following
measures: (1) reorient or relocate the receiving antenna;
(2) increase the separation between the equipment and
the receiver; (3) connect the equipment to an outlet on
a circuit dierent from that to which the receiver is
connected; (4) consult the dealer or an experienced radio/TV
technician for additional suggestions.
Any changes or modifications not expressly approved by
the party responsible for compliance could void the user’s
authority to operate the equipment. Where shielded
interface cables have been provided with the product or
specified additional components or accessories elsewhere
defined to be used with the installation of the product,
they must be used in order to ensure compliance with FCC
regulation.
Canadian DOC statement
DOC Class B compliance—This Class B digital apparatus
complies with Canadian ICES-003.
Observation des normes-Class B—Cet appareil
numérique de la classe B est conforme à la norme
NMB-003 du Canada.
Status LED:
Green — charging
O — charging complete
Eastman Kodak Company
Rochester, NY 14650 U.S.A.
© Kodak, 2010. MC/MR/TM: Kodak. 4H7394