s-bag
TM
indicator and changing the s-bag
TM
For peak performance the s-bag
TM
should be changed when full. The
mechanical s-bag
TM
indicator window will gradually turn red when filling
and completely red when full.
If the dust bag should get broken in the cleaner, take cleaner to service
centre for cleaning. This is not covered by the guarantee.
The s-bag
TM
full indicator may signify that the bag is blocked
(occasionally caused by finer dust) which will cause loss of suction and
may result in overheating. If this occurs change the bag even if it is not
full. DO NOT VACUUM VERY FINE DUST (PLASTER, CEMENT, COLD CINDERS...).
To check the dustbag, the cleaner must be switched on, with all
attachments connected but the nozzle does not have to be placed on the
floor.
To change the s-bag
TM
:
7 Open the cleaner cover.
8 Remove the s-bag
TM
holder and pull the sliding tab to remove the s-
bag
TM
from its holder.
9 Insert the new s-bag
TM
by sliding the bag slots into the holder. Close
cover.
10 Make sure that the dustbag (s-bag
TM
) is not overlapping with the
rubber sealing. (Push downwards before inserting the dustbag holder
into the dustbag compartement)
We recommend the s-bag
TM
is changed after using a carpet cleaning
powder or if there is a bad smell from the cleaner.
Note: Only use original s-bags
TM
and filters
s-bag
TM
(ref. s-bag
TM
)
Motor protection filter (ref. D55)
Exhaust filter/Micro filter (ref. D09)
s-bag
TM
safety device
To avoid damaging the cleaner, do not use it without a dust bag. A safety
device is fitted which prevents the cover closing without a dust bag in
place. Do not attempt to force cover shut.
Changing/cleaning the filters
Never use the cleaner without the filters in place.
The filters should be changed/cleaned approximately every fifth dust bag.
To maintain Motor Protection filter:
7 Open the cleaner cover.
11 Remove the filter unit, rinse the filter under warm tap water only and
dry the filter completely (14). The original filtering performance is
now restored. Replace the unit back into the cleaner and close cover
ensuring it is securely in place and the cover is properly closed.
Latest every second year replace the old filter with a new one.
To maintain Exhaust filter/Micro filter (some models):
12 Press the catch to open the filter cover.
13 Remove the filter unit, rinse the filter under warm tap water only and
dry the filter completely (14). The original filtering performance is
now restored. Replace the unit back into the cleaner and close cover
ensuring it is properly fastened.
Latest every second year replace the old filter with a new one.
Troubleshooting
Dustbag: please check that the dustbag is placed correctly and ensure
that it is not jammed. (10)
Power: if the electric power does not come on, disconnect from mains
and check plugs, cable and fuses where appropriate.
The cleaner may switch itself off in event of severe blockage or
excessively dirty filters. In such cases, disconnect from mains and allow
to cool for 30 minutes. Clear blockage and/or replace filter(s) and restart.
The clearing of blocked hoses is not covered by the guarantee. To avoid
blockages and maintain suction efficiency, the floor nozzles should be
cleaned regularly using the hose handle.
Please see additional Volta information towards the back of this booklet.
Water: if water is sucked into the cleaner the motor must be changed at a
service centre. This is not covered by the guarantee.
4