FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be
installed and operated with minimum distance between 20cm the radiator your body: Use
only the supplied antenna.
The use of the 5150 – 5250 MHz band is restricted to indoor use only. This restriction
will be applied in all member states.
IC Caution
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the
following two conditions
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
The device has been evaluated to meet general RF exposure requirement. The device can be used
in portable exposure condition without restriction.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux apparei ls radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
Pour maintenir la conformité aux directives d'exposition aux radiofréquences, cet équipement doit
être installé et utilisé avec une distance minimale de 20 cm entre le radiateur et votre corps.
This radio transmitter 27122-WN539N5 has been approved by Innovation, Science and Economic
Development Canada to operate with the antenna types listed below, with the maximum
permissible gain indicated. Antenna types not included in this list that have a gain greater than the
maximum gain indicated for any type listed are strictly prohibited for use with this device.
ANT
Manufacturer
Model
Peak
Gain
Type
Frequency range
impedance
A
Shenzhen Jiexixi
Technology Co., Ltd.
ANT A
1dBi
External
antenna
2400-2483.5MHz
& 5150MHz-5250MHz
&5725MHz-5850MHz
50Ω
B
Shenzhen Jiexixi
Technology Co., Ltd.
ANT B
1dBi
External
antenna
2400-2483.5MHz
& 5150MHz-5250MHz
&5725MHz-5850MHz
50Ω
-
1
-
2
-
3
