FCC Part 15C
Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.NOTE: This equipment has been
tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation.If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation. FCC RF Radiation Exposure
Statement
Caution: To maintain compliance with the FCC’s RF exposure guidelines, place the unit at least 20cm from
nearby persons.
Industry Canada Regulatory Information
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux conditions suivantes: (1) l’appareil ne doit pas produire de
brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
INSIDE THE BOX:
CS1 Thermostat
Power Wire
Mounting Screws
Wall Anchors
Wire Labels
Wall Plate
Screwdriver
1
2
3
4
5
6
7
1
2
3
4
5
6
7
DOWNLOAD THE LUX APP FOR
INSTALLATION INSTRUCTIONS
Easy WiFi
Setup
Money & Energy
Saving Features
Step by Step
Instructions
LUXproducts.com
-
1
-
2
dans d''autres langues
- English: Lux CS1 Quick start guide
Autres documents
-
TP-LINK KC200 Mode d'emploi
-
iHome iW18 Bedside/Office Clock Manuel utilisateur
-
Johnson Controls KONOse Mode d'emploi
-
iHome iW18 Bedside/Office Clock Mode d'emploi
-
Trendnet TEW-740APBO2K Quick Installation Guide
-
Arris VAP2500 Guide de démarrage rapide
-
TP-LINK KC120 Mode d'emploi
-
Araknis Networks AN-110-RT-2L1W-WIFI Guide de démarrage rapide