La page charge ...
La page charge ...
La page charge ...
CS6080 配件 法規指南
4
United States and Canada Regulatory
Radio Frequency Interference Notices
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules.These limits are designed to provide reasonable protection against
harmfulb interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Radio Frequency Interference Requirements – Canada
Innovation, Science and Economic Development Canada ICES-003 Compliance Label: CAN ICES-3
([B])/NMB-3([B])
This device complies with Innovation, Science and Economic Development Canada’s licence-exempt
RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of
the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire
de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radio électrique subi même si le
brouillage est susceptible d'en compromettre le fonctionnement.
RF Exposure Requirements - FCC and ISED
The FCC has granted an Equipment Authorization for this device with all reported SAR levels evaluated in
compliance with the FCC RF emission guidelines. SAR information on this device is on file with the FCC
and can be found under the Display Grant section of www.fcc.gov/oet/ea/fccid
.
Mobile Devices
This equipment complies with RF Exposure limits established for an uncontrolled environment (General
Population). This equipment should be installed and operated in such a way that a separation distance of
greater than 20 centimeters is maintained between the transmitter's radiating structure(s) and the body of
the user or nearby persons.
Cet équipement est conforme aux limites d'exposition aux RF établies pour un environnement non contrôlé
(population générale). Cet équipement doit être installé et utilisé de manière à maintenir une distance de
séparation supérieure à 20 centimètres entre la (les) structure (s) rayonnante (s) de l'émetteur et le corps
de l'utilisateur ou des personnes à proximité.
La page charge ...
La page charge ...
La page charge ...
-
1
-
2
-
3
-
4
-
5
-
6
-
7
dans d''autres langues
- English: Zebra CS6080 Owner's manual
Documents connexes
-
Zebra MC2200 Le manuel du propriétaire
-
Zebra MC2X Le manuel du propriétaire
-
-
Zebra TC21 Le manuel du propriétaire
-
-
-
-
-
Zebra ATR7000 Guide de référence
-