FCC Statement
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
Warning: Changes or modifications not expressly
approved by the party responsible for compliance could
void the user's authority to operate the equipment.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation.
This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following measures: (1) Reorient or relocate
the receiving antenna. (2) Increase the separation between
the equipment and receiver. (3) Connect the equipment
into an outlet on a circuit different from that to which the
receiver is connected. (4) Consult the dealer or an
experienced radio/TV technician for help.
FCC Radio Frequency Exposure Statement
The device has been evaluated to meet general RF exposure
requirements. The device can be used in fixed/mobile
exposure condition. The min separation distance is 20cm.
Notice: Shielded cables
All connections to other computing devices must be made
using shielded cables to maintain compliance with FCC
regulations.
The following importer is the responsible party
Company Name: Fantasia Trading LLC
Address: 9155 Archibald Avenue, Suite 202, Rancho
Cucamonga, CA 91730, USA
Telephone:1-909-484-1530
This product complies with the radio interference
requirements of the European Community.
Declaration of Conformity
Hereby, Anker Innovations Limited declares that this device
is in compliance with the essential requirements and other
relevant provisions of Directive 2014/53/EU. For the
declaration of conformity, visit the Web site
www.eufylife.com
Do not use the Device in the environment at too high or
too low temperature, never expose the Device under
strong sunshine or too wet environment.
The suitable temperature for eufyCam 2C and accessories
is -20°C-50°C.
When charging, please place the device in an environment
that has a normal room temperature and good ventilation.
It is recommended to charge the device in an environment
with a temperature that ranges from 5°C~25°C.
RF exposure information: The Maximum Permissible
Exposure (MPE) level has been calculated based on a
distance of d=20 cm between the device and the human
body. To maintain compliance with RF exposure
requirement, use product that maintain a 20cm distance
between the device and human body.
CAUTION RISK OF EXPLOSION IF BATTERY IS
REPLACED BY AN INCORRECT TYPE. DISPOSE OF
USED BATTERIES ACCORDING TO THE
INSTRUCTIONS.
6 NOTICE
09 10