INSTALLATION INSTRUCTIONS

334 - LED Pendant

• Read all instructions before installing.

• System is intended for installation by a licensed electrician in accordance with the National Electrical Code (NEC) and local regulations.

• Retain installation instructions for future maintenance reference.

All parts must be used as indicated in these instructions. This product is designed for use only with the supplied parts and/or

accessories designated for use by dweLED. Substitution of parts or accessories not designated for use with this product by dweLED

• Lors de la manipulation du luminaire, n’appuyez pas sur les LED. Tenez-le uniquement par la base.

Toutes les pièces doivent être utilisées comme indiqué dans ces instructions. Ce produit est conçu pour être utilisé seulement

avec les pièces et/ou accessoires fournis pour être utilisés avec les produits dweLED. Remplacer des pièces ou accessoires non conçus

pour ce produit dweLED pourrait causer des dommages corporels ou matériels et pourrait également causer l’annulation de la

garantie. Veuillez contacter un revendeur autorisé ou le fabricant si des pièces manquent ou sont endommagées.

Les conditions côtières peut causer une accumulation de minéraux et de résidue sur le luminaire. Nous recommendons

aux clients qui resident dans les zones côtières de nettoyer toutes les surfaces externes du luminaire une fois toutes les deux semaines avec

Phone (800) 526.2588

Fax (800) 526.2585

44 Harbor Park Drive

Port Washington, NY 11050

PREPARATION

1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.

2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to

lose any small parts necessary for installation.

MOUNTING THE FIXTURE (Fig. 1)

3. Remove the Canopy screw (C) from the ceiling plate.

4. The lamp can switch between four color temperatures (2700K-3000K-3500K-4000K),

which can be adjusted to your preference with the switch mounted in the canopy. (Fig.2).

Note: the switch comes with removable protective cover, Remove the cover prior

6. Choose the number of the rods suitable for your application. Thread the xture wire

through the rods, swivel and canopy. Connect the xture, rods and swivel. Make sure all are tightened.

CONNECTING THE WIRES(Fig. 3, Fig. 4)

7. Connect the driver’s output wires , xture’s wires and 4CCTswitch ‘s wires together

using wire connectors (B) as shownin Fig .4.

8. Connect the driver input wires to junction box as shown in Fig .3. Making sure that

all wire connectors (A) are secured. If your outlet box has a green or bare copper

ground wire, connect the xture’s ground wire to it. Otherwise, connect the

xture’s ground wire directly to the back plate using the GND screwprovided.

After wires are connected, tuck them carefully inside the junction box.

copper ground wire (ground).

COMPLETING THE INSTALLATION (Fig. 1)

12. Secure the canopy to the ceiling plate use the canopy screw (C).

Black or

Fixture Wires

House Wires

White

(Neutral)

House Wires

Green or Bare Copper

(Ground)

Phone (800) 526.2588

Fax (800) 526.2585

44 Harbor Park Drive

Port Washington, NY 11050

1600 Distribution Ct

Lithia Springs, GA 30122

1750 Archibald Avenue

Ontario, CA 91760