VTech Switch & Go® 3-in-1 Rescue Rex Manuel utilisateur

Switch & Go® 3-in-1 Rescue Rex
VTech
Marque
VTech
Modèle
Switch & Go® 3-in-1 Rescue Rex
Catégorie
Jouets d'apprentissage
Taper
Manuel utilisateur

Ce manuel convient également à

Instruction Manual
3
-
I
N
-
1
3
-
I
N
-
1
®
3-IN-1 RESCUE REX3-IN-1 RESCUE REX
Scan For
Animation
Scan for
Assembly Video
2
INTRODUCTION
Switch into fun with the Switch & Go® 3-in-1 Rescue Rex! Combine these
3 rescue vehicles into a mega rescue T-Rex. Split the T-Rex apart and send
each on separate rescue missions. Let’s go!
LCD Screen
LED Light
Light Button
Talk Button
Off/Low/High
Volume Selector
LED Light
3
INCLUDED IN THE PACKAGE
• Switch & Go® 3-in-1 Rescue Rex
• Quick Start Guide
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part of
this toy, and should be discarded for your child’s safety.
NOTE
Please save this manual as it contains important information.
ATTENTION
Pour la sécurité de votre enfant, débarrassez-vous de tous les produits
d’emballage tels que rubans adhésifs, feuilles de plastique, attaches,
étiquettes, cordons et vis d’emballage. Ils ne font pas partie du jouet.
NOTE
Il est conseillé de sauvegarder ce manuel car il comporte des
informations importantes.
INSTRUCTIONS
GETTING STARTED
The 3-in-1 Rescue Rex is in try-me mode in the packaging. To exit try-me
mode, just transform the “Dino Head Mode” to “Vehicle Mode” or connect
the Dino Head to the Dino Body (Rescue Helicopter).
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
4
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the
back of the unit, use a screwdriver to
loosen the screw, and then open the
battery cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 2 new AA (AM-3/LR6) batteries
following the diagram inside the battery box. (For best performance,
alkaline batteries or fully charged Ni-MH rechargeable batteries are
recommended).
5. Replace the battery cover and tighten the screw to secure.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
•
Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended are to
be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.
RECHARGEABLE BATTERIES
• Remove rechargeable batteries (if removable) from toy before charging.
• Rechargeable batteries are only to be charged under adult
supervision.
• Do not charge non-rechargeable batteries.
5
IMPORTANT : INFORMATIONS CONCERNANT LES PILES
Les piles fournies avec le produit permettent de tester le jouet en magasin
mais ne sont pas des piles longue durée.
• Mettre en place les piles ou les accumulateurs en respectant les polarités
+ et –.
• Ne pas mélanger des piles ou des accumulateurs neufs avec des usagés.
• Ne pas mélanger différents types de piles : alcalines, zinc-carbone et
rechargeables.
• Seules des piles du type recommandé doivent être utilisées.
• Ne pas mettre les bornes d’une pile ou d’un accumulateur en court-circuit
(en reliant directement le + et le –).
• Retirer les piles ou les accumulateurs en cas de non-utilisation prolongée.
• Enlever les piles ou les accumulateurs usagés du jouet.
• Ne les jeter ni au feu ni dans la nature.
PILES RECHARGEABLES :
• Enlever, lorsque c’est possible, les accumulateurs du jouet pour les
recharger.
• Les accumulateurs ne doivent être chargés que sous la
surveillance d’un adulte.
• Ne pas tenter de recharger des piles non rechargeables.
6
PRODUCT FEATURES
1. Off/Low/High Volume Selector
To turn the unit On or adjust the volume, slide
the switch to the Low or High volume
position. To turn the unit Off, slide the switch
to the Off position.
2. Talk Button
Press the Talk Button to hear fun phrases
and cool dino sounds with light effects in T-Rex
mode or to hear fun phrases and police car
sounds in Vehicle mode.
3. Light Button
Press the Light Button to play cool light
effects and sound effects.
4. LCD Screen
The LCD Screen shows dino eye animations
in Dino mode and shows driver animations in
Vehicle mode.
5. Automatic Shut-Off
To preserve battery life, the unit will automatically shut off after approximately
20 seconds without input. The unit can be turned on again by pressing the
Game Button or Light Button or by switching between Dino Head mode and
Vehicle mode or combine the dino head with the dino body. The unit will also
automatically turn off when battery power is very low.
NOTE
If the unit powers down or if the light flashes 3 times without sounds during play,
please install a new set of batteries.
7
TRANSFORMATION
Transforming from Dino Head Mode
to Police Car Mode
1. Begin in Dino Head Mode.
2. Flip the windshield forward.
1
2
Scan for
Assembly Video
8
2. Flip up the Dino’s mouth and flip the jaw cover backward.
3
4. Swing the side panels out.
5
4
9
6. The Dino Head is now in Police Car Mode.
5. Fold the side panels forward.
6
7
10
1
2
3
To combine the Rescue Rex, follow the below steps to switch the Police Car
back to the Dino Head.
11
5
4
6
7
12
Transforming from Helicopter Mode to Dino Body Mode
1. Begin in Helicopter Mode.
2. Flip both landing skids out.
1
2
13
3. Rotate 2 of the propeller blades toward the center .
4. Flip the claws out.
5.Rotate both arms up.
3
4
5
14
Transforming from Fire Engine Mode to Dino Legs Mode
1. Begin in Fire Engine Mode.
2. Flip the base cover to the front.
1
2
15
3. Swing both legs forward.
4. Flip the ladder back.
3
4
5
16
5. Flip the legs down.
6. Flip the toes forward.
6
8
7
17
7. Spread the toes and adjust the legs and feet for stability.
8. Flip the cab of the fire engine up and fold the engine grill backward.
10
9
18
9. The Fire Engine is now in Dino Legs Mode.
NOTE
To switch the Dino Head, Dino Body and Dino Legs back into the Police
Car, Helicopter and Fire Engine, follow the above steps in reverse order.
11
19
COMBINATION
1. Combine the Dino Body with the Dino Legs.
1
2
3
20
2. Snap the Dino Head to the Dino Body.
La page charge ...
La page charge ...
La page charge ...
La page charge ...
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24

VTech Switch & Go® 3-in-1 Rescue Rex Manuel utilisateur

Switch & Go® 3-in-1 Rescue Rex
VTech
Marque
VTech
Modèle
Switch & Go® 3-in-1 Rescue Rex
Catégorie
Jouets d'apprentissage
Taper
Manuel utilisateur
Ce manuel convient également à
Télécharger le PDF
rapport

dans d''autres langues

Documents connexes