IFM E21002 Guide d'installation

  • Bonjour, je suis votre assistant IA. J'ai examiné le document sur le kit de montage OJ../FO. Ce document décrit les étapes d'installation du kit sur un profilé en aluminium. Je suis prêt à répondre à toutes vos questions concernant ce guide de montage.
  • Où dois-je monter les écrous ?
    Comment fixer la bride ?
    Quand dois-je serrer la vis (g) définitivement ?
(i)
(g)
(g)
Montieren Sie zwei passende Nutsteine (nicht im Lieferumfang) in die Nut des
Aluprofils. Befestigen Sie den Halter (a) mit den beiden Schrauben (b) und schieben
Sie den Gewindewürfel (c) hinein. Drehen Sie die Schraube (d) in den Gewindewürfel
und kontern Sie die Schraube mit der Mutter (e).
Ziehen Sie nach Montage und Ausrichtung des Sensors die Schraube (g) fest.
Befestigen Sie den Haltewinkel (i) und ziehen Sie anschließend die Schraube (g)
soweit an, daß sich der Winkel noch drehen läßt.
Montieren Sie die beiden Schellenhälften (f) lose mit Hilfe der beiliegenden Schraube
(g) und Mutter (h).
Montageanleitung Montagesatz OJ../FO Aluprofil
Installation instructions mounting kit OJ../FO
for aluminium profile
Notice de montage kit de montage OJ../FO pour
profil aluminium
701613/00 01/01 ifm electronic gmbh . Friedrichstraße 1 . D 45128 Essen
1
2
3
4
Fasten the two parts of the mounting clamp (f) loosely by means of the screw (g)
and the nut (h) supplied.
Monter les deux parties de la bride de fixation (f) provisoirement à l'aide de la vis
(g) et de l'écrou (h) livrés.
Attach the mounting bracket (i) and then tighten the screw (g) in such a way that
the bracket can still be turned.
Fixer l'équerre de fixation (i) et ensuite visser la vis (g) de façon que l'équerre puisse
toujours être tournée.
Tighten the screw (g) fully after the sensor has been mounted and aligned.
Serrer la vis (g) définitivement après avoir monté et aligné la cellule.
Mount two suitable slot nuts (not supplied) into the slot of the aluminium profile.
Fasten the bracket (a) with the two screws (b) and insert the threaded cube (c). Turn
the screw (d) into the threaded cube and lock it with the nut (e).
Monter deux écrous appropriés (non fournis) dans la rainure du profil aluminium.
Fixer la bride (a) avec les deux vis (b) et insérer le cube fileté (c). Tourner la vis (d)
dans le cube fileté et la bloquer avec l'écrou (e).
(a)
(b)
(c)
(d)
(e)
(f)
(g)
(h)
1/1