FCC Statement
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference
responsible for compliance could void the user’s authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
•
•
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
RF exposure warning
This equipment must be installed and operated in accordance with provided
instrucons and antenna(s) used for this transmier must be installed to provide a
separaon distance of at least 20cm from all persons and must not be co-located or
operang in conjuncon with any other antenna or transmier. End-users and
installers must be provided with antenna installaon instrucons and transmier
operang condions for sasfying RF exposure compliance.
The equipment should be installed and operated with a minimum distance 20cm
between the radiator and your body.
IC Statement
This device complies with Industry Canada licence-exempt RSS standard(s).
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux
suivantes :
1. L’appareil ne doit pas produire de brouillage, et
2.
This equipment should be installed and operated with a minimum distance 20cm
between the radiator and your body.
le radiateur et votre corps.
type and its gain should be so chosen that the equivalent isotropically radiated power
type d’antenne et son gain de sorte que la puissance isotrope rayonnée équivalente
The user manual for local area network devices shall contain instructions related to the
restrictions mentioned in the above sections, namely that:
IV
(i) the device for operation in the band 5150-5250 MHz is only for indoor use to reduce
the potential for harmful interference to co-channel mobile satellite systems;
(ii) the maximum antenna gain permitted for devices in the band 5725-5850 MHz shall
comply with the e.i.r.p. limits specified for point-to-point and non point-to-point
operation as appropriate.
(i)Les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés
uniquement pour une utilisation à l'intérieur afin de réduire les risques de brouillage
préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux.
(ii) le gain d'antenne maximal autorisé pour les appareils dans la bande 5725-5850
MHz doivent respecter le pire limites spécifiées pour le point-à-point et l'exploitation
non point à point, le cas échéant.
Users should also be advised that high-power radars are allocated as primary users (i.e.
priority users) of the bands 5725-5850 MHz and that these radars could cause
interference and/or damage to LE-LAN devices.
Les utilisateurs de radars de haute puissance sont désignés utilisateurs principaux (c.-à-
d., qu'ils ont la priorité) pour les bandes 5725-5850 MHz et que ces radars pourraient
causer du brouillage et/ou des dommages aux dispositifs LAN-EL.
-
1
-
2
