●Products shall be subject to any changes without additional notices due
to DawnSun will keep innovation and optimization on the products.
FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1)This device may not cause harmful interference
This device must accept any interference received including interference that may
cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
(2) ,
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and use in accordance with
the instructions, may cause harmful interference to radio communications.
However there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
1.Reorient or relocate the receiving antenna.
2.Increase the separation between the equipment and receiver.
3.Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
4.Consult the dealer or an experienced radio/TV technician for help.
.
,
IC STATEMENT
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
this device may not cause harmful interference and
this device must accept any interference received, including interference that may cause
undesired operation.
Avis d'Industrie Canada (IC): Cet appareil est conforme avec Industrie Canada exempts de
licence standard RSS (s).
Son fonctionnement est soumisaux deux conditions suivantes
cet appareil ne doit pas provoquer d interférences et
cet appareil doit accepter toute interférence, y compris celles pouvant causer un mauvais
fonctionnement de l'appareil.
Votre appareil est conçu et fabriqué pour ne pas dépasser les limites d'émission pour
l'exposition à l énergie RF établie par le gouvernement du Canada (IC). Les informations
sur votre appareil sont en fichier avec l'IC et peuvent être trouvées sous la section Affichage
Grant de https://sms-sgs.ic.gc.ca/equipmentRechercher après la recherche sur l'IC pour
votre appareil, qui se trouve sur le À l arrière de l'appareil.
(1) ,
(2)
:
(1) '
(2)
'
'
Information concernant l'exposition à l énergie radiofréquence'
OPERATION INSTRUCTION