Crestron TSW-570P Information produit

Taper
Information produit
TSW-570P
5 in. Wall Mount TouchScreen, Portrait
Product Information - 8684A
(2055434)
02.20
Getting Started
Scan the QR code to view the Quick Start Guide.
www.crestron.com/docs/8683
For additional information on the Crestro TSW-570P, visit
www.crestron.com/model/6510838
Certification and Compliance
Regulatory Model: M201923001
Federal Communications Commission (FCC) Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is
subject to the following conditions:
(1) This device may not cause harmful interference and (2) this device
must accept any interference received, including interference that
may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user’s
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
l Reorient or relocate the receiving antenna.
l Increase the separation between the equipment and receiver.
l Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
l Consult the dealer or an experienced radio/TV technician for help.
Industry Canada (IC) Compliance Statement
CAN ICES-3 (B)/NMB-3(B)
As of the date of manufacture, the product has been tested and
found to comply with specifications for CE marking.
装置B報技術装置で置は庭環境で使
力く装置受信機に近接し使用さ受信
害を起こ取扱説明書に従っ正し取り下さ
This is a class B product based on the standard of the VCCI Council.
If this is used near a radio or television receiver in a domestic
environment, it may cause radio interference. Install and use the
equipment according to the instruction manual.
IMPORTANT NOTE: To comply with FCC RF exposure compliance
requirements, the antenna used for this transmitter must be
installed to provide a separation distance of at least 20 cm from all
persons and must not be co-located or operating in conjunction with
any other antenna or transmitter.
REMARQUE IMPORTANTE: Pour être conforme aux exigences de
conformité dISED CANADA et de la FCC en matière dexposition aux
radiofréquences, l’antenne utilisée pour cet émetteur doit être
installée de manière à assurer une distance de séparation d’au moins
20 cm de toutes les personnes. toute autre antenne ou émetteur.
ISED Canada: This device contains licence-exempt transmitter
(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canadas licence-exempt RSS(s). Operation is subject
to the following two conditions: 1. This device may not cause
interference. 2. This device must accept any interference, including
interference that may cause undesired operation of the device.
Lémetteur/cepteur exempt de licence contenu dans le présent
appareil est conforme aux CNR dInnovation, Sciences et
Développement économique Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes : 1. Lappareil ne doit pas produire de brouillage; 2.
Lappareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d’en compromettre le fonctionnement.
The device may contain radios capable of transmitting in the
5150–5350 MHz frequency range (such as 5GWi-Fi® networks).This
frequency is restricted to indoor use only.
The Waste Electrical & Electronic Equipment (WEEE) directive
marking on a product indicates that it should not be disposed of with
general waste. Instead, you are encouraged to reuse or recycle the
product in accordance with Directive 2012/19/EU of the European
Union. Proper disposal of this product will help prevent potential
negative effects on the environment and human health, which could
otherwise be caused by inappropriate waste handling. Penalties may
be applicable for incorrect disposal of this waste, in accordance with
your national legislation. For information about recycling this
product, please contact your household waste disposal service, your
original distributor, or Crestron.
Crestron Electronics, Inc.
15 Volvo Drive, Rockleigh, NJ 07647
Tel: 888.CRESTRON
Fax: 201.767.7656
www.crestron.com
Product Information - Doc. 8684A
(2055434)
02/25/20
Legal
The product warranty can be found at www.crestron.com/warranty.
The specific patents that cover Crestron products are listed at
www.crestron.com/legal/patents.
Certain Crestron products contain open source software. for specific
information, visit www.crestron.com/opensource.
Crestron and the Crestron logo are either trademarks or registered
trademarks of Crestron Electronics, Inc. in the United States and/or
other countries. Wi-Fi is either a trademark or registered trademark
of Wi-Fi Alliance in the United States and/or other countries. Other
trademarks, registered trademarks, and trade names may be used in
this document to refer to either the entities claiming the marks and
names or their products. Crestron disclaims any proprietary interest
in the marks and names of others. Crestron is not responsible for
errors in typography or photography.
©2020 Crestron Electronics, Inc.
  • Page 1 1
  • Page 2 2

Crestron TSW-570P Information produit

Taper
Information produit

dans d''autres langues