TRIDENT In-Ground
MADE IN
CANADA
PROUD MEMBER OF
1
Drill a 22mm hole and install supplied nipples
according to your electrical layout.
A1
Wiring may also be end fed.
4
Lay down your desired flooring, keeping level with
the top of the Trident channel.
SEE NOTE B ON PAGE 2
2
Drill holes at base of channel and secure to ground.
SEE NOTE A ON PAGE 2
5
Remove plastic spacer.
3
Run your electrical conduit and junction box.
Mount junction box to the channel. Place
supplied spacer into the channel.
Read and follow these
instructions before installing or
maintaining this product
Veuillez lire et suivre ces
instructions avant l’installation ou
l’entretien de ce produit
• Make sure this product is NOT on the same
circuit as inductive loads, (e.g. fluorescent bulbs,
discharge bulbs, ventilation fans, etc...)
• Do not switch on line voltage until all wiring is
complete
• Incorrect wiring will result in irreparable damage
to LED and power supply
• This product should only be installed by a
licensed electrician
• Assurer vous que des charges inductives ne se
retrouvent pas sur le même circuit que ce produit,
(i.e. fluorescent, ampoules à décharge,
ventilateurs, etc...)
• Compléter les branchements avant de mettre
sous tension
• Un branchement incorrect créerait des
dommages irréparables à l’alimentation et au DEL
• Ce produit devrait être uniquement installé par un
électricien qualifié
Warranty
Garantie
• This product must be installed in accordance with
all applicable installation codes and ordinance
• Limited five (5) years warranty
• Warranty is void in the eventuality of unauthorized
modifications and/or improper use
• Ce produit doit être installé conformément au code
d’installation et autres normes applicables
• Garantie limitée de cinq (5) ans
• La garantie est non valide advenant une modification
non autorisée ou un usage non approprié
B
TRIDENT In-Ground
MADE IN
CANADA
PROUD MEMBER OF
7
Insert the next section of Trident after the anchor.
Once in place, drop the mounting block over the
anchor, between both sections of trident.
A
Before installation, drill drainage hole at each end
of your run of Trident channel.
8
Secure block and anchor in place using the
included tamper resistant screw and driver.
Repeat steps 6 through 8 for all runs of Trident.
B
Be sure to leave adequate space under the
channel for proper drainage.
9
NOTES:
6
Install first section of Trident followed by the
anchor at the open end. Pushing the anchor
against Trident.
-
1
-
2
luminii Trident Recessed Outdoor Guide d'installation
- Taper
- Guide d'installation
- Ce manuel convient également à
dans d''autres langues
Documents connexes
-
luminii Leto 44 Mini WM UD Guide d'installation
-
-
-
-
-
-
-