Lumination LBR Series LED Luminaire Diff Guide d'installation

Lumination
Marque
Lumination
Modèle
LBR Series LED Luminaire Diff
Taper
Guide d'installation
LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved. Information and specifications subject to change
without notice. All values are design or typical values when measured under laboratory conditions.
Page 1 of 2
(Rev 06/28/23)
IND126-Lumination-BR-Series-LED-Luminaire-Difuser-Replacement-Installation-Guide_R01
Installation Guide
IND126
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING/ AVERTISSEMENT
RISQUES DE DÉCHARGES ÉLECTRIQUES
• Coupez l’alimentation avant d’’inspecter, installer ou déplacer le
luminaire.
• Assurez-vous de correctement mettre à la terre le boîtier
d’alimentation électrique.
RISQUES D’INCENDIE
• Respectez tous les codes NEC et codes locaux.
• N’Utilisez que des ls approuvés par UL pour les entrées/ sorties de
connexion. Taille minimum 18 AWG (0.75mm2).
SAVE THESE INSTRUCTIONS
Use only in the manner intended by the manufacturer. If you have any questions, contact the manufacturer.
Description Code Corresponding Luminaires
22 diuse Backlit Troer 22 series
14 diuser Backlit Troer 14 series
24 diuser Backlit Troer 24 series
RISK OF ELECTRIC SHOCK
• Turn power o before inspection, installation or removal.
• Properly ground electrical enclosure.
RISK OF FIRE
• Follow all NEC and local codes.
• Use only UL approved wire for input/output connections.
Minimum size 18 AWG (0.75mm2).
Lumination® LED Luminaire
LED Diuser Replacement
(BR Series)
Specications
LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved. Information and specifications subject to change
without notice. All values are design or typical values when measured under laboratory conditions.
Page 2 of 2
(Rev 06/28/23)
IND126-Lumination-BR-Series-LED-Luminaire-Difuser-Replacement-Installation-Guide_R01
Lumination® (BR - Series) Installation Guide
Diuser Replacement Steps
Note: The following depic the 22 series luminaire. However, the procedure is thre same for the 14 and 24 series xtures
Rotate latches to unlock the front bezel.
1
Swing down panel and lift o front bezel with diuser
2
Place front bezel with diuser on table. Unfasten
the two rail screws on the end rail with latches,
then remove this end rail.
3
Locate round corner here
Remove the old diuser by sliding it toward the
side without end rail. Insert new diuser, keeping
the round corner of diuser on bottom right.
4
Reattach end rail with screws.
5
Hang panel on its hinges and swing up into place.
Rotate latches on front bezel to fasten it.
Note: Front side of diuser should face outward.
6
  • Page 1 1
  • Page 2 2

Lumination LBR Series LED Luminaire Diff Guide d'installation

Lumination
Marque
Lumination
Modèle
LBR Series LED Luminaire Diff
Taper
Guide d'installation
Télécharger le PDF
rapport

dans d''autres langues

Documents connexes

Autres documents