E-Label User Information
FCC ID: SWX-U6EPIW
IC ID: 6545A-U6EPIW
Ubiquiti Inc. will be incorporating the E-Label procedures per FCC KDB 784748-D02. The
information below is what will be included in the E-Labeling.
E-label and warning statements can be found in the device/controller GUI under Device >
Settings > About.
Detailed compliance information including Declaration of Conformity is available at the
following internet address: ui.com/compliance
FCC
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions.
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generated, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operations of this equipment in a residential
area is likely to cause harmful interference in which case the user bill be required to correct
the interference at his own expense.
• FCC regulations restrict the operation of this device to indoor use only.
• The operation of this device is prohibited on oil platforms, cars, trains, boats, and
aircraft, except that operation of this device is permitted in large aircraft while flying
above 10,000 feet.
• Operation of transmitters in the 5.925-7.125 GHz band is prohibited for control of or
communications with unmanned aircraft systems.
ISED Canada
CAN ICES-3 (A) / NMB-3 (A)
This device complies with ISED Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference received, including interference that may
cause undesired operation.
CAN ICES-3 (A) / NMB-3 (A)
Le présent appareil est conforme aux CNR d’ISDE Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:
1. L’appareil ne doit pas produire de brouillage;
2. I’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
RF Exposure Warning
The antennas used for this transmitter must be installed to provide a separation distance of
at least 20 cm from all persons and must not be located or operating in conjunction with
any other antenna or transmitter.
Les antennes utilisées pour ce transmetteur doivent être installé en considérant une
distance de séparation de toute personnes d’au moins 20 cm et ne doivent pas être localisé
ou utilize en conflit avec tout autre antenne ou transmetteur.
-
1
-
2
dans d''autres langues
- English: Ubiquiti SWX-U6EPIW User manual
Autres documents
-
TP-LINK tp-link EAP660 HD Omada Ceiling Mount Access Point Le manuel du propriétaire
-
TP-LINK tp-link EAP660 HD Ceiling Mount EAP Mode d'emploi
-
TP-LINK tp-link Omada EAP660 HD V1 Ceiling Mount Access Point Le manuel du propriétaire
-
Asus ROG Rapture GT-BE98 Pro Guide de démarrage rapide
-
-
-
Asus RT-BE96U Guide de démarrage rapide
-