imou A1 Mode d'emploi

Catégorie
Les routeurs
Taper
Mode d'emploi
A1
Quick Start Guide
www.imoulife.com
Welcome
Thank you for choosing IMOU.
We are devoted to providing you easy smart home
products. If you have problems using the product, please
contact our service team before returning your product.
Our service mail: service.global@imoulife.com
Detailed installation instructions & videos, frequently asked
questions can be found at: imoulife.com/support/help
Or scan this QR code to help page.
Package content
Camera introduction
Quick Start Guide ×1
Camera ×1 Power Cable ×1 Power Adapter ×1 Positioning Map ×1
Built-in Mic
Lens
LED Indicator
Note:
Press and hold the reset button for 10 s to reset the camera.
The pattern of the LED indicator is included in the following table.
LED Status
Green light on
Green and red light
flashing alternately
Powered off/LED turned off
Rebooting after reset
Booting
Device malfunction
Waiting for network
Off
Red light on
Firmware updating
Device Status
Green light flashing
Network connection failed
Red light flashing
Operating properly
Built-in Speaker
Micro SD
Card Slot
Power Port
Ethernet Port
Reset/Pair
Button
Imou Life
Tips
i
To ensure the best possible wireless performance, please make sure there are
no obstacles and electromagnetic interference between the camera and router.
Setup
WIFI Name
Password
Next
Setup
Done
+45
-10
DC
5V2A
Ceiling Mounting (Optional)
Mounting
Surface
Positioning
Map
Expansion
Bolt
Mounting
Plate
Self-tapping
Screw
Camera
1
2
3
Troubleshooting
Problem Solution
• Ensure your mobile device and the camera are within range of your
Wi-Fi router.
• Ensure the LED indicator on the camera isflashing green before
beginning setup.
Cannot set up camera
• Reset your Camera and connect it again.
• Some cameras only support 2.4GHz, while some routers have dual
band, 2.4G/5G. Make sure you are connecting 2.4GHz only.
The APP says "Failed
to configure device
network"
The camera is already connected to Wi-Fi, but the router is:
• Not connected to Internet
• Poor network status
• The Wi-Fi signal is not stable due to obstacles or electronic
interference
The app says “
Failed to bind”
• Ensure the LED indicator on the camera is flashing steady green.
See ‘LED Status’ section for details if otherwise.
• Ensure the camera is properly connected to power using the
included USB power adapter.
• Try repositioning the camera, router, or both to improve signal
strength.
No picture / signal
• Check the camera lens for dirt, dust, spider webs. Clean the lens with
a soft, clean cloth.
• Remove the vinyl cover on the camera lens.
Picture is not clear
• Ensure audio function on camera is turned on.
• Ensure audio is turned up on viewing device.
No audio
• Ensure you have enabled “Human Detection” in the Device Settings
screen of the Imou LifeApp.
Human detection
not working
• Turn off Camera Shielding in Device Settings on the Imou Life app.
Camera stuck
downwards
• Clean the camera lens of your Smartphone
• Ensure that there is enough light on the QR code
• Don’t hold the QR code too close to the camera
Phone is not
reading QR code
This product complies with the applicable CE marking directives
and standards:
CE-Electromagnetic Compatibility (EMC)
Low Voltage (LVD) Directive 2014/35/EU.
Electromagnetic Compatibility (EMC) Directive 2014/30/EU.
Restrictions of Hazardous Substances (RoHS) Directive 2011/65/EU
and its amending Directive (EU) 2015/863.
CE-Safety
Declaration of Conformity CE
(Only for the product has RF function)
A copy of the original declaration of conformity may be obtained from
Dahua Technology. The most up to date copy of the signed EU
Declaration of Conformity (DoC) can be found
www.imoulife.com/declaration-of-conformity
This digital equipment is compliant with Class B according to EN 55032.
This product complies with IEC/EN/UL 60950-1 or IEC/EN/UL 62368-1,
Safety of Information Technology Equipment.
Hereby, Dahua Technology declares that the radio equipment is
compliant with Radio Equipment Directive (RED) 2014/53/EU. The full
text of the EU declaration of conformity is available at www.imou-
life.com/declaration-of-conformity
A1
Kurzanleitung
www.imoulife.com
Willkommen
Vielen Dank, dass Sie sich für IMOU entschieden haben.
Wir sind bestrebt, einfachere Produkte für das intelligente
Heim anzubieten. Wenn Sie Probleme bei der Verwendung
des Produkts haben, wenden Sie sich bitte an unser
Serviceteam.
Unsere Service-Mail lautet: [email protected]
Detaillierte Installationsanweisungen und Videos sowie
häufig gestellte Fragen, bitte finden Sie unter:
imoulife.com/support/help
Oder scannen Sie diesen QR-Code zur Hilfeseite.
Packungsinhalt
Einführung in die Kamera
Kurzanleitung ×1
Kamera ×1 Stromkabel ×1 Netzteil ×1 Bohrlochschablone
×1
Built-in Mic
Objektiv
LED-Anzeige
Hinweis:
Halten Sie die Rücksetz-/Kopplungstaste 10 Sekunden lang gedrückt, um die Kamera zurückzusetzen.
Das Muster der LED-Anzeigen ist in der folgenden Tabelle aufgeführt.
Eingebauter
Lautsprecher
MicroSD-
Kartensteckplatz
Stromanschluss
Ethernet-
Anschluss
Rücksetz-/
Kopplungstaste
Abgeschaltet/LED Ausgeschaltet
Gerät fährt nach Rücksetzung hoch
Gerät fährt hoch
Gerätestörung
Warten auf
Firmware-Update
Netzwerkverbindung fehlgeschlagen
Ordnungsgemäßer Betrieb
LED-Status/Gerätestatus
Grüne und rote LED
blinken abwechselnd
Grüne LED leuchtet
AUS
Rote LED leuchtet
Device Status
Grüne LED blinkt
Rechte LED blinkt
Imou Life
Tips
i
Um die bestmögliche Funkübertragung zu gewährleisten, stellen Sie sicher,
dass zwischen Kamera und Router keine Hindernisse und elektromagnetische
Störungen vorhanden sind.
Setup
WIFI Name
Password
Next
Setup
Done
+45
-10
DC
5V2A
1
2
3
Montage-Oberfläche
/-Decke
Montageschablone
Dübel
Mounting Plate
Selbstschneidende
Schraube
Kamera
Deckenmontage (optional)
Fehlerbehebung
Problem Lösungen
• Stellen Sie sicher, dass Ihr mobiles Gerät und die Kamera in
Reichweite Ihres WLAN-Routers sind.
• Vergewissern Sie sich, dass die LED-Anzeige an der Kamera grün
blinkt, bevor Sie mit der Einrichtung beginnen.
Kamera kann nicht
eingerichtet werden
camera is already connected to Wi-Fi, but the router is:
• Not connected to Internet
• Poor network status
• The Wi-Fi signal is not stable due to obstacles or electronic
interference
The app says “
Failed to bind”
• Ensure the LED indicator on the camera is flashing steady green.
See ‘LED Status’ section for details if otherwise.
• Ensure the camera is properly connected to power using the
included USB power adapter.
• Try repositioning the camera, router, or both to improve signal
strength.
No picture / signal
• Check the camera lens for dirt, dust, spider webs. Clean the lens with
a soft, clean cloth.
• Remove the vinyl cover on the camera lens.
Picture is not clear
• Ensure audio function on camera is turned on.
• Ensure audio is turned up on viewing device.
No audio
• Ensure you have enabled “Human Detection” in the Device Settings
screen of the Imou LifeApp.
Human detection
not working
• Turn off Camera Shielding in Device Settings on the Imou Life app.
Camera stuck
downwards
• Clean the camera lens of your Smartphone
• Ensure that there is enough light on the QR code
• Don’t hold the QR code too close to the camera
Phone is not
reading QR code
This product complies with the applicable CE marking directives
and standards:
CE-Electromagnetic Compatibility (EMC)
Low Voltage (LVD) Directive 2014/35/EU.
Electromagnetic Compatibility (EMC) Directive 2014/30/EU.
Restrictions of Hazardous Substances (RoHS) Directive 2011/65/EU
and its amending Directive (EU) 2015/863.
CE-Safety
Declaration of Conformity CE
(Only for the product has RF function)
A copy of the original declaration of conformity may be obtained from
Dahua Technology. The most up to date copy of the signed EU
Declaration of Conformity (DoC) can be found
www.imoulife.com/declaration-of-conformity
This digital equipment is compliant with Class B according to EN 55032.
This product complies with IEC/EN/UL 60950-1 or IEC/EN/UL 62368-1,
Safety of Information Technology Equipment.
Hereby, Dahua Technology declares that the radio equipment is
compliant with Radio Equipment Directive (RED) 2014/53/EU. The full
text of the EU declaration of conformity is available at www.imou-
life.com/declaration-of-conformity
A1
www.imoulife.com
Guía de inicio rápido
Bienvenido
Gracias por elegir IMOU
Nuestra misión es proporcionar productos fáciles de usar
para un hogar inteligente. Si tiene problemas usando el
producto, por favor diríjase a nuestro equipo de atención
al cliente antes de devolver su producto.
Nuestro correo electrónico de servicio:
Nos comprometemos a contestarle en 24 horas.
Encontrará instrucciones y videos detallados de instalación,
preguntas más frecuentes en: imoulife.com/support/help
O escanee este código QR para las páginas
de ayuda.
Contenido del paquete
Introducción a la cámara
Guía de inicio rápido
×1
Cámara ×1 Cable de alimentación
×1
Adaptador de corriente
×1
Plantilla de
posicionamiento ×1
Micrófono
integrado
Lente
Indicador LED
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28
  • Page 29 29
  • Page 30 30
  • Page 31 31
  • Page 32 32
  • Page 33 33
  • Page 34 34
  • Page 35 35
  • Page 36 36
  • Page 37 37
  • Page 38 38
  • Page 39 39
  • Page 40 40
  • Page 41 41
  • Page 42 42
  • Page 43 43
  • Page 44 44
  • Page 45 45
  • Page 46 46
  • Page 47 47
  • Page 48 48
  • Page 49 49
  • Page 50 50
  • Page 51 51
  • Page 52 52
  • Page 53 53
  • Page 54 54
  • Page 55 55
  • Page 56 56
  • Page 57 57

imou A1 Mode d'emploi

Catégorie
Les routeurs
Taper
Mode d'emploi

dans d''autres langues