Koala Kare KB100-ST Installation and Operation Instructions
- Taper
- Installation and Operation Instructions
®®
KOALA KARE PRODUCTS
Installation and Operation Instructions
KB100-ST and KB110-SSRE
Baby Changing Stations
Cambiador Plegable
Table à Langer
Babywickelstation
IMPORTANT. RETAIN FOR FUTURE REFERENCE. READ CAREFULLY.
IMPORTANTE. GUÁRDELO PARA FUTURAS CONSULTAS. LEER ATENTAMENTE.
IMPORTANT. À CONSERVER POUR INFORMATION. À LIRE ATTENTIVEMENT.
WICHTIG. ZUR SPÄTEREN BEZUGNAHME AUFBEWAHREN. BITTE SORGFÄLTIG DURCHLESEN.
You are responsible for the safe operation of this unit.
KB100-ST & KB110-SSRE Operating Instructions
Tools Needed
Hardware Provided
Please Note: To assure proper installation, it is suggested that a qualied person or carpenter install
the Koala Baby Changing Station. Koala Kare Products will not be responsible if the station is not
installed properly. Koala Baby Changing Stations have been tested to hold a substantial static load. The
unit must be attached to a permanent wall that is capable of holding a substantial load. The maximum
recommended total weight for this baby changing station (including baby and parcel bag) is 60 lbs.
Excessive weight may cause a hazardous or unstable condition to exist.
Restraint System: To fasten the waist restraint strap, place strap around child’s midsection, and
push spring tabs into buckle until both spring tabs lock in place with an audible “click”. Straps can be
adjusted to make strap tighter or looser as required.
Inspection Criteria:
• A properly maintained baby changing station:
• Opens and closes smoothly
• Has both ends of a functioning, non-frayed strap:
buckle clicks when closed and strap is attached to unit at both ends.
• Offers parents liners through a fully stocked liner dispenser. (Dispenser built into unit.)
• Provides a clean, convenient place for customers to attend to their children.
gloves
level
drill
measuring
tape
1/8” (3 mm)
(regular & masonry)
drill bits
four ¼” (6 mm)
flat washers
stud finder
pencil
Phillips head
screwdriver
four 1/4”x 3” (6mm x 76mm)
Phillips panhead wood screws
KB100-ST & KB110-SSRE Installation Instructions
Step 1.
Remove changing station from the shipping
container and check for any freight damage.
Identify the best location for installing the unit.
Hold the unit in place and open the bed. Make
sure you have taken the operating clearance
into consideration.
Step 2.
Select the wall area where the unit will be
installed. Measure from the oor 46½” (1181
mm) on stud center and mark the wall. Hold the
unit in place to verify the alignment. Mark rough
opening 35½” W x 20½” H (902 mm x 521 mm)
and cut a hole in the wall with a minimum depth
of 4¼” (108 mm) as measured from the nished
surface of the wall (ie: tile, drywall, etc). Construct
mounting frame as indicated in the illustration.
If the wall surface is masonry or tile over wood
studs, use caution when cutting rough opening.
Step 3.
Mount the unit using four ¼” x 3” wood screws
through side holes as shown in illustration.
Step 4.
Place the unit into the recessed area and use the side mounting holes as a guide to drill a pilot hole
using a 1/8” drill bit. Insert the screws and at washers through the side mounting holes to hold the
unit in place. It may be necessary to adjust the level of unit by using a shim on the top right or left side
of the unit before tightening securely to the studs.
Step 5.
Position Koala sign (supplied) on the outside of the restroom door. Fill the built-in dispenser with
sanitary bed liners. Replacement parts and additional liners can be purchased from your local
distributor or by calling toll free 888.733.3456 or 303.539.8300 in the U.S.
KB100-ST & KB110-SSRE ASTM F 2285-04 (2016)
ENGLISH
WARNING:
Never leave child unattended.
WARNING: Avoid serious injury from
falling or sliding out. Always use restraint system.
WARNING: Designed for Infants Only.
Age up to 3.5 years and weighing less than 50 lbs
(22.7 kg). Keep one hand on the child at all times.
Parcels or accessory items, or both, placed on the
unit may cause the unit to become unstable.
FRANÇAIS
ATTENTION:
Ne laissez jamais un enfant sans surveillance.
ATTENTION: Évitez les blessures
occasionnées par une chute ou une glissade.
Utilisez toujours le système de retenue.
ATTENTION: Conçue uniquement pour
les jeunes enfants. Jusqu’à 3 ans et demi et moins
de 50 lb (22.7 kg). Conservez une main sur l’enfant
à tout moment.
Tout paquet ou accessoire placé sur la table peut
créer un déséquilibre.
ESPAÑOL
ADVERTENCIA:
No deje nunca al niño desatendido.
ADVERTENCIA: Evite que el niño se
lesione por caerse o resbalarse del cambiador Use
siempre el sistema de sujeción.
ADVERTENCIA: Diseñado exclusiva-
mente para bebés. Hasta 3 años y medio de edad
y con un peso inferior a 50 libras (22,7 kg aproxi-
madamente). Mantenga siempre al niño sujeto con
una mano.
Colocar paquetes o accesorios, o ambas cosas,
encima del cambiador puede provocar que se
desestabilice.
DEUTSCH
WARNUNG:
Das Kind niemals unbeaufsichtigt lassen.
WARNUNG: Ernsthafte Verletzungen
durch Herausfallen oder Herausrutschen verhin-
dern. Immer das Rückhaltesystem verwenden.
WARNUNG: Dieses Produkt ist nur für
Kleinkinder bis zu 3 1/2 Jahren und einem Gewicht
von höchstens 50 lbs. (22.7 kg) vorgesehen. Das
Kind immer mit einer Hand festhalten.
Durch Ablegen von Päckchen und Zubehör auf der
Wickelstation kann diese instabil werden.
Koala Kare Products A Division of Bobrick
6982 South Quentin St., Centennial, CO 80112-3945
Main 303.539.8300 Toll Free 888.733.3456
Fax 303.539.8399
Koalabear.com
P/N 520- April 2017
-
1
-
2
-
3
-
4
Koala Kare KB100-ST Installation and Operation Instructions
- Taper
- Installation and Operation Instructions
dans d''autres langues
- English: Koala Kare KB100-ST
- Deutsch: Koala Kare KB100-ST
Documents connexes
-
Koala Kare 489-KIT Mode d'emploi
-
-
-
Koala Kare 311-32-KIT Mode d'emploi
-
Koala Kare KB200-SS Guide d'installation
-
-
-
-