HP HSC-L03WC Mode d'emploi

Taper
Mode d'emploi
Safety & Regulatory Guide for [HSC-L03WC Wireless
Charger Module].
Product NameWireless Charger Module
Brand Name hp
Type NumberHSC-L03WC
Input12Vdc 2A
Output:15W Max.
It is a 15W WPC wireless charger module for charging
a single phone or phablet.
Wireless charger is built into the base of select HP AIO or PC base unit All-in-One
computers. Place any Qi-enabled device on the base for charging.
1.Place the device on the base of the computer.
2. Position the device wireless charging coil directly on top of the square icon
on the on the base
note: The label does not affect the wireless charging function.
Troubleshooting charging issues
If the wireless charging feature does not work as expected, verify the following:
Make sure that your mobile device is capable of wireless charging. See the product
specifications of your mobile device.
Make sure that your mobile device is placed correctly on the base .
This booklet provides important safety, regulatory information that you should read before
you start using your [HCS-L03WC Wireless Charger]
To avoid damaging your device, accessories or any connected devices, and to reduce the risk
of personal injury, discomfort, property damage or other potential hazards, follow these
precautions below :
Handle your [HSC-L03WC Wireless Charger Module] with care. You may damage the
device if you disassemble, drop, bend, burn, crush or puncture your device. Using a
damaged device may cause overheating or injury. Don’t expose your [HCS-L03WC
Wireless Charger Module] to liquids, which can cause a short circuit and overheating.
The [HSC-L03WC Wireless Charger Module] is designed to work best in ambient
temperatures between 0 and 40° C.
Maintain a distance of 10 cm from your body to be consistent with how the device is
tested for compliance with RF exposure requirements.
Hereby, HP Inc. declares that the radio equipment type HSC-L03WC is in compliance
with Directive 2014/53/EU. The full text of the EU declaration of conformity is
available at the following internet address: http://www.hp.com/go/orderdocuments
Hereby, HP Inc. declares that the radio equipment type HSC-L03WC is in compliance
with RER 2017 (SI 2017/1206). The full text of the UK declaration of conformity is
available at the following internet address: http://www.hp.com/go/orderdocuments
In accordance with Article 10.8(a) and 10.8(b) of the RED, the following table
provides information on the frequency bands used and the maximum RF transmit
power of the product for sale in the EU,UK:
WPC
Frequency range
Output power
120-130kHz
< 0 dBuA/m@10m
RF Exposure Information (MPE)
This device meets the EU requirements and the International Commission on Non-
Ionizing Radiation Protection (ICNIRP) on the limitation of exposure of the general
public to electromagnetic fields by way of health protection.
Waste Electrical and Electronic Equipment (WEEE) & Batteries Directive
[or]
The WEEE symbol above means that according to local laws and regulations your product
[and its battery] must be disposed of separately from household waste. When this product
reaches its end of life, take it to a collection point designated by local authorities for safe
disposal or recycling. The separate collection and recycling of your product and its battery
will help conserve natural resources, protects human health, and help the environment.
EMC Compliance
Important: This device and power adapter have demonstrated Electromagnetic Compatibility
(EMC) compliance under conditions that included the use of compliant peripheral devices
and shielded cables between system components. It is important that you use compliant
peripheral devices and shielded cables between system components to reduce the
possibility of causing interference to radios, televisions, and other electronic devices.
Changes or modifications to this product not authorized by hp could void the
electromagnetic compatibility (EMC) and wireless compliance and negate your authority to
operate the product.
Regulatory Information: United States
FCC REGULATORY COMPLIANCE
Note: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by hp could void your
authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following 2 conditions:
1 These devices may not cause harmful interference.
2 These devices must accept any interference received, including interference
that may cause undesired operation.
Maintain a distance of 20 cm (8 inches) from your body to be consistent with how the
device is tested for compliance with RF exposure requirements.
FCC ID: 2APXN-HSCL03WC
EMC COMPLIANCE STATEMENT
Important: This device [and its power adapter] have demonstrated
Electromagnetic Compatibility (EMC) compliance under conditions that included
the use of compliant peripheral devices and shielded cables between system
components. It is important that you use compliant peripheral devices and
shielded cables between system components to reduce the possibility
of causing interference to radios, televisions, and other electronic devices.
RADIO FREQUENCY EXPOSURE
This device meets the U.S. Federal Communications Commission’s (FCC)
requirements for exposure to radio waves and is designed and manufactured not to
exceed the FCC’s emission limits for exposure to radiofrequency (RF) energy. To
comply with FCC RF exposure compliance requirements, this device must not be co-
located or operating in conjunction with any other antenna or transmitter.
Innovation, Science and Economic Development (ISED)
Canada Regulatory Compliance
IC: 24654-HSCL03WC
INDUSTRY CANADA, CLASS B
This Class B digital apparatus complies with CAN ICES-003(B)/NMB-003(B).
Innovation, Science and Economic Development Canada (ISED Canada)/Innovation,
Sciences et veloppement économique Canada Industry Canada/Industrie
This device complies with ISED’s licence-exempt RSSs. Operation is subject to the
following two conditions: (1) This device may not cause interference; and (2) This
device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'ISED Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, me si le brouillage est susceptible d'en
compromettre le fonctionnement.
Radio Frequency Exposure/Exposition aux radiofréquences
The output power of the radio technology used in the Device is below the radio
frequency exposure limits set by ISED for an uncontrolled environment.
Maintain a distance of 10 cm from your body to be consistent with how the device is tested for
compliance with RF exposure requirements.
La puissance de sortie de la technologie radio utilisée dans le riphérique est inférieure aux
limites d'exposition aux fréquences radio finies par ISED Canada pour un environnement non
contrôlé.
Maintenez une distance de 10 cm de votre corps pour être cohérent avec la façon dont l’appareil est
testé pour la conformité aux exigences d’exposition RF.
NCC
無線設備警告聲明
取得審驗證明之低功率射頻器材,非經核准,公司、商號或使用者 均不得
擅自變更頻率、加大功率或變更原設計之特性及功能。低功 率射頻器材之
使用不得影響飛航安全及干擾合法通信;經發現有干 擾現象時,應立即停
用,並改善至無干擾時方得繼續使用。前述 法通信,指依電信管理
規定作業之無線電通信。低功率射頻器材須忍受合法通信或工業、科學及
醫療用電波輻射性電機設備之干擾。
To access the latest user guide, go to http://www.hp.com/support, and select your country.
Select Drivers & Downloads, and then follow the on-screen instructions.
*You can find the expressly provided HP Limited Warranty applicable to your product located
with the user guides on your tablet and/or on the CD/DVD provided in the box. In some
countries/regions, HP may provide a printed HP Limited Warranty in the box. For
countries/regions where the warranty is not provided in printed format, you may request a
printed copy from http://www.hp.com/go/orderdocuments or write to:
North America: Hewlett-Packard, MS POD, 11311 Chinden Blvd., Boise, ID 83714, USA
● Europe, Middle East, Africa: Hewlett-Packard, POD, Via G. Di Vittorio, 9, 20063, Cernusco
s/Naviglio (MI), Italy
● Asia Pacific: Hewlett-Packard, POD, P.O. Box 200, Alexandra Post Office, Singapore 911507
When you request a printed copy of your warranty, please include your product number,
warranty period (found on your service label), name, and postal address.
IMPORTANT: Do NOT return your HP product to the addresses above.
For U.S. support, go to http://www.hp.com/go/ contactHP.
For worldwide support, go to http://welcome.hp.com/country/us/en/wwcontact_us.html.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

HP HSC-L03WC Mode d'emploi

Taper
Mode d'emploi

dans d''autres langues