LETO 11 WM Wet
1 Rev January 20, 2022 403-216-7043 | [email protected]
MADE IN
CANADA
PROUD MEMBER OF
Overview / Vue d’ensemble
Install bracket so that fixture lines up with the desired orientation.
Leto 11 WM Wet may only be installed on smooth flat surfaces. Uneven surfaces such as
brick will not ensure a water tight seal.
Use Dowsil 1199 silicone glazing sealant or equivalent.
FOR LETO 11 WM WET & WM UD WET
Read and follow these
instructions before installing or
maintaining this product
Veuillez lire et suivre ces
instructions avant l’installation ou
l’entretien de ce produit
• This product is suitable for DAMP OR WET
LOCATIONS
• Make sure this product is NOT on the same
circuit as inductive loads, (e.g. fluorescent bulbs,
discharge bulbs, ventilation fans, etc...)
• Allow air to flow freely around the fixture
• Do not switch on line voltage until all wiring is
complete
• Incorrect wiring will result in irreparable damage
to LED and power supply
• This product should only be installed by a
licensed electrician
• Ce produit convient pour une installation DANS
UN ENDROIT HUMIDE ET MOUILLÉ
• Assurer vous que des charges inductives ne se
retrouvent pas sur le même circuit que ce produit,
(i.e. fluorescent, ampoules à décharge,
ventilateurs, etc...)
• Permettre à l’air de circuler librement autour du
luminaire
• Compléter les branchements avant de mettre
sous tension
• Un branchement incorrect créerait des
dommages irréparables à l’alimentation et au DEL
• Ce produit devrait être uniquement installé par un
électricien qualifié
Warranty
Garantie
• This product must be installed in accordance
with all applicable installation codes and
ordinance
• Limited five (5) years warranty
• Warranty is void in the eventuality of
unauthorized modifications and/or improper use
• Ce produit doit être installé conformément au
code d’installation et autres normes applicables
• Garantie limitée de cinq (5) ans
• La garantie est non valide advenant une
modification non autorisée ou un usage non
approprié
LETO 11 WM Wet
2 Rev January 20, 2022 403-216-7043 | [email protected]
MADE IN
CANADA
PROUD MEMBER OF
Installation / Installation
2
Make DC electrical connections. Aline
Leto 11 WM Wet to the tabs on the bracket.
1
Mount bracket to wall or junction box. Make
sure the tabs are level horizontally.
Apply silicone around the edge between
the wall and the canopy. Apply silicone to
each set screw hole as well.
4
Push Leto 11 WM Wet tightly against the
wall. Secure in place using the 2 set screws.
3
5
Be sure to fill the area shown above. Keep
the bead smooth with no air gaps.
5
-
1
-
2
dans d''autres langues
- English: luminii Leto 11 WM User manual
Documents connexes
-
luminii LETO 11 Manuel utilisateur
-
-
-
-
-
-
-
-
-